Results 1 to 5 of 5
Thread: Surf gate stuck, pdm fault
-
07-18-2021, 05:54 PM #1Member
- Join Date
- Sep 2020
- Posts
- 56
Surf gate stuck, pdm fault
Anyone have this before? At cruise the left and right tabs would deploy for 3 seconds then retract and then do it again until the third time only the port ran stayed down and the screen showed pdm (i think) fault. I’ve seen this on other forums and it looks like they do some sort of recalibration and it fixes it but any ideas? Made it undriveable above 10 mph.
2021 Supra SE
-
07-18-2021, 06:10 PM #2Senior Member
- Join Date
- Aug 2011
- Posts
- 2,522
I have a different boat(Craz) but my surf system was recently going crazy like yours. I traced it to the pdm, when I disconnected the wire connectors they had water shorting it out. Dried out the connectors and added some dielectric grease. The pdm(large black rectangle and says pdm on it) is located behind the back walls behind that port side ballast wall on my boat.
http://www.instgram.com/jlyons30
2002 Moomba Mobius LSV - Sold
2006 Moomba Mobius LSV - Sold
2017 Moomba Craz - Enzos, Lead
-
07-18-2021, 06:16 PM #3Senior Member
- Join Date
- Aug 2011
- Posts
- 2,522
Also try turning the main power on off to reset things.
http://www.instgram.com/jlyons30
2002 Moomba Mobius LSV - Sold
2006 Moomba Mobius LSV - Sold
2017 Moomba Craz - Enzos, Lead
-
07-18-2021, 09:35 PM #4Member
- Join Date
- Sep 2020
- Posts
- 56
-
07-18-2021, 10:13 PM #5Senior Member
- Join Date
- Aug 2011
- Posts
- 2,522
http://www.instgram.com/jlyons30
2002 Moomba Mobius LSV - Sold
2006 Moomba Mobius LSV - Sold
2017 Moomba Craz - Enzos, Lead