Results 1 to 10 of 17
Thread: When to change out the prop?
-
07-10-2021, 09:46 PM #1
When to change out the prop?
New boat…. About 32 hours on her… hit a log… not hard just enough to slightly bend 2 blades right at the tip… just a few millimeters deep… and a couple cm across…. Pretty slight. Did not notice and shutter, vibrations, or anything unusual. Ok to run? Thoughts? Thanks in advance!
2021 Moomba Max 400
-
07-10-2021, 09:48 PM #2
Order back up prop, keep using current prop, swap new prop, send damaged prop to get fixed.
Sent from my iPhone using Tapatalk2021 Supra SA 400
2018 Supra SA 400 (SOLD)
Michigan
-
07-10-2021, 10:07 PM #3
What Larry said
Sent from my iPhone using Tapatalk
-
07-10-2021, 10:24 PM #4
Ok will do…. What is the drive shaft size on this? Have to buy the removal tool too. Thanks!
2021 Moomba Max 400
-
07-10-2021, 10:32 PM #5
1 1/8”
Sent from my iPhone using Tapatalk2021 Supra SA 400
2018 Supra SA 400 (SOLD)
Michigan
-
07-10-2021, 10:42 PM #6
-
07-11-2021, 10:39 AM #7
Another newb question…. If I bought the wakemakers prop…acme 2277 15x15.75…. It’s a half inch smaller and a little more low end. I like where the stock one has me right now. Will this one by any significant changes? Improvements? I guess just want to make sure I’m staying where I want to be….
Right now is the stock general use 15.5x16.5
Thanks2021 Moomba Max 400
-
07-11-2021, 10:42 AM #8
When to change out the prop?
Last edited by larry_arizona; 07-11-2021 at 10:47 AM.
2021 Supra SA 400
2018 Supra SA 400 (SOLD)
Michigan
-
07-11-2021, 10:59 AM #9
-
07-11-2021, 11:50 AM #10
I have a 15.5X15 on mine with the 400 motor. Top end is still 38, and pulls really well loaded.
Sent from my moto z4 using Tapatalk2021 Moomba Makai
Black Cherry Metal Flake & Fire Red
Nibral OJ 15.5x15 Altitude/Wake prop w/1.76 trans v-drive
Wet Sounds bow speakers & 10's on the Tower & ported sub