Moomba Makai registration number placement

[HFarr]

Does anyone have any photos of where they placed their decal and registration numbers on a Moomba Makai? My paint scheme seems to present a little bit of a challenge for spacing. There is a vent (might be the horn) located on the drivers side of the boat that makes my space limited for putting them just under the rub rail. Just curious if anybody else has a similar scheme they have put numbers on.



Sent from my moto z4 using Tapatalk

[Cfoosh11]

Does anyone have any photos of where they placed their decal and registration numbers on a Moomba Makai? My paint scheme seems to present a little bit of a challenge for spacing. There is a vent (might be the horn) located on the drivers side of the boat that makes my space limited for putting them just under the rub rail. Just curious if anybody else has a similar scheme they have put numbers on.

Sent from my moto z4 using Tapatalk

That vent is indeed your horn. Here is my placement on my 2018 Craz



Sent from my iPhone using Tapatalk

[HFarr]

Those look sharp. Looks like they match the MOOMBA letters exactly. I think the front hull lines on the Makai are a little different though. It seems to have more breaks in it. I have roughly 21 inches to work with.

Sent from my moto z4 using Tapatalk

[HFarr]

I didn't see your reg decal. Where did you put it?

Sent from my moto z4 using Tapatalk

[TXSurf4]

Had the same issue on our Makai. Here is what I had to do. I wasn’t in love with having to go above the rub rail but it was the only space the legal spacing would fit. I even had to get a second set of domed numbers as the first color combo I had was for a black background.




Sent from my iPhone using Tapatalk

[Cfoosh11]

I didn't see your reg decal. Where did you put it?

Sent from my moto z4 using Tapatalk

Put it between the horn vent and registration letters.


Sent from my iPhone using Tapatalk

[Holdmybeer]

Use the horn vent as the 6 inch separation then use the 21 inches of space you have to fit the numbers.

[HFarr]

Use the horn vent as the 6 inch separation then use the 21 inches of space you have to fit the numbers.

Didn't think about that. I may have to look at this as an option. On the other side of the boat there is a "clean emissions" logo that I may have to cover, but that wouldn't bother me.

Sent from my moto z4 using Tapatalk

[HFarr]

TXsurf4,
I forgot that I had already seen your boat pics in some other posts. That doesn't look too bad. I may end up that route. From the pics above, it looks like our front ends are slightly different? Maybe its just where the Gatorstep is placed, or light reflections. Did anything change on these from 19 to 21?

Sent from my moto z4 using Tapatalk

[Holdmybeer]

Didn't think about that. I may have to look at this as an option. On the other side of the boat there is a "clean emissions" logo that I may have to cover, but that wouldn't bother me.

Sent from my moto z4 using Tapatalk

The emissions sticker is a %%$$**$& to get off. Not sure about a new boat, but trying to remove them from old trucks for replacement is a pain.

You will need to buffer and polish for sure if you go that route.