Results 1 to 10 of 14
Thread: Darkness in metal flake
-
04-09-2021, 07:10 PM #1
Darkness in metal flake
I have some darkness at the waterline in the flake on my boat
There is no texture change in the gel coat. Tried to compound a test area no luck.
Any one have any tips for getting that out??
Sent from my iPhone using Tapatalk2016 Moomba Helix Surf Edition
2003 Moomba Mobius LS Gone
-
04-09-2021, 07:26 PM #2
Does this boat sit in the water a lot? Or is the water you operate the boat in dirty? I drove my boat in the St Croix River once which has a lot of minerals in it. Apparently not cleaning the boat left a nasty scum line. Being white gel coat it was very apparent. Nothing would remove it till I got this stuff. If it’s a nasty scum line this stuff will get it off but you have to use it exactly as instructed.
https://www.westmarine.com/buy/davis...53?recordNum=5
Sent from my iPhone using Tapatalk
-
04-09-2021, 07:38 PM #3
It usually sits in the water. When you run your hand over it there is no difference in the gel coat texture. Ive cleaned it and compounded the area and nothing. Maybe ill have to give that stuff a try.
Sent from my iPhone using Tapatalk2016 Moomba Helix Surf Edition
2003 Moomba Mobius LS Gone
-
04-10-2021, 10:05 AM #4
-
04-10-2021, 10:11 AM #5
-
04-10-2021, 03:10 PM #6
Update: went to west marine today and grabbed that fiberglass stain remover and some on and off as recommended by the guy there. Tried a test spot, Nothing worked. Tired to wet sand with 800, 1500, than hit it with compound, nothing... not sure what to do.
Sent from my iPhone using Tapatalk2016 Moomba Helix Surf Edition
2003 Moomba Mobius LS Gone
-
04-10-2021, 03:33 PM #7
Must be some funky water you store your boat in. I’ve heard of people using muriatic acid to clean off barnacles and tough grime on fiberglass boats. Yours doesn’t seem like you’d need something like that since there is no growth but clearly something is staining the surfaces below the water line.
https://www.boats.net/blog/tips-for-...iberglass-hull2019 Moomba Max "MOOMBAE"
Mods: Wakemakers upgrade + 500 lbs of lead
2016 Yamaha AR192 - sold
-
04-10-2021, 06:27 PM #8
Is it possible UV fading?
Sent from my iPhone using Tapatalk2021 Supra SA 400
2018 Supra SA 400 (SOLD)
Michigan
-
04-10-2021, 07:08 PM #9
I left this out as well, its only on the metal flake on the port side of the boat. Very strange.
Sent from my iPhone using Tapatalk2016 Moomba Helix Surf Edition
2003 Moomba Mobius LS Gone
-
04-10-2021, 08:08 PM #10