Board Rack Install Help?

[SW_WAKE]

I have a 2020 Moomba Craz. It did not come with board racks. I ordered Wake/surf racks and mag swivels from Roswell. When you look at The Moomba A3 Tower page on Roswell's site, there is what appears to be a spacer between the swivel and the board rack backing plate. I cannot find this part to order. Is it needed or not necessary? Anyone with a similar experience?

[SONIC]

Just call roswell and ask?

[MJHSupra]

I would think any Tower Adaptor would be sold through Roswell for the different rack options.

Not sure why that part would not be sold with the racks.

[ktenan12]

I have a 2020 Moomba Craz. It did not come with board racks. I ordered Wake/surf racks and mag swivels from Roswell. When you look at The Moomba A3 Tower page on Roswell's site, there is what appears to be a spacer between the swivel and the board rack backing plate. I cannot find this part to order. Is it needed or not necessary? Anyone with a similar experience?

I think you’re talking about this? I’m pretty sure you don’t need it. My racks came fixed to the tower and I think that was just a spacer between the tower and the backing plate. I put it on my swivels but don’t think it was necessary. Maybe it’s to accommodate for longer screws when the rack is fixed? I know that’s not a very definitive answer, but I think you can mount the plate directly to the swivel.

If you look at the photo at the top of the “Board Racks” tab on the website, there is no spacer installed on that one.

[spatty99]

In looking at my setup, I also think it is just a spacer you don't need. Mine is installed with swivel, but I don't notice where there would be interference without it. Roswell's instructions even call it a spacer.