Results 41 to 50 of 102
-
01-11-2021, 10:17 AM #41
-
01-11-2021, 11:11 AM #42
Looks good. I wish I had done more with CNC when I was younger. I’m jealous of anyone that has the skills and equipment to do this. One of the things the factory ones have is a rubber or urethane gasket at the mating surface. Sonics mounts are one piece, whereas the stock ones are two piece. I think his will be stronger and easier to mount.
2020 SA 450 Wife calls it White Cloud. Said it makes her feel "Classy"
2017 Sanger V215sx. We call it Viagra because it's the little blue pill that gets everyone up (Sold)
-
01-11-2021, 11:36 AM #43
Yeah the factory ones cover the bolt holes but after a lot of consideration I like the one piece design better and there are exposed stainless bolts all over the tower so having them exposed doesn't detract from anything and it's stronger since it's not relying on smaller bolts to hold the faceplate on.
Working on the gaskets as well I'll probably laser cut some.
It's never too late for cnc. I started with a cheap router 10 years ago and now I've got cnc routers lasers plasmas mills and robots. Just takes practice and there's a huge community around hobby level cnc.2020 Supra SA
-
01-16-2021, 09:05 PM #44
Man, those are nice! The chamfered edges look sweet. You need to make some for the A3 towers (higher volume) and you'd make a fortune!
-
01-18-2021, 09:33 AM #45
Send me some measurements and I'm happy to. I don't have one nearby to measure!
2020 Supra SA
-
01-18-2021, 11:51 PM #46
sonic those are pretty darn good lookin..... you need to expand to other boats. I miss the ability to tie my rope off on the side when I had the alpha z tower. SOO much easier when training noobs to force them to the wake side.
'06 Supra Launch 20SSV-gone but never forgotten
-
01-19-2021, 09:14 AM #47
I'm working on it, did some for a buddy with a '19 MB this weekend, I just don't have access to enough boats to get the measurements.
MVIMG_20210115_150747.jpg2020 Supra SA
-
01-19-2021, 01:27 PM #48
-
01-19-2021, 02:05 PM #49
-
01-19-2021, 02:41 PM #50
Thanks,
Making a change in the overall shape as I think it needs an angle on the back to match the tower.2020 Supra SA