Results 1 to 3 of 3
Thread: Engine Pull Help
-
07-08-2020, 06:56 PM #1Junior Member
- Join Date
- Jun 2020
- Posts
- 2
Engine Pull Help
First Im sorry if there is a post on this but I have searched the forums, all of them, and have not found a good detailed description on pulling an engine.
Second Im begging for help because I did not get a response on the Supra forums.
I have a 2003 Supra Launch SSV - Oil pan rusted out around the drain plug. Not a huge leak but enough that running it with the leak is asking for more complete engine teardown.
Can someone provide me with any helpful information on pulling the engine? I purchased the Clymer manual which is relatively straight forward but some first hand knowledge of how to or what to watch out for would be appreciated.
-
07-08-2020, 07:20 PM #2
not going to be able to help and not a skiers product BUT if you peruse the tige forums there's some help there.
1 guy bought an older boat and is completely redoing it. he has pics of engine work and there's some posts on watchouts on the engine install. sorry- don't remember the thread title but you may run across it.
this below is a guy rebuilding the boat from hull up. he might have some info if you reach out to him:
https://www.tigeowners.com/forum/gen...-the-ground-up
secondly search out boatwakes and id_boating as a member on there. both are boat mechanics and have posted up tips/tricks over the years.
know it's not a supra forum but those older boats have a lot of similarities among the brands.'06 Supra Launch 20SSV-gone but never forgotten
-
07-08-2020, 11:02 PM #3Junior Member
- Join Date
- Jun 2020
- Posts
- 2
Thank you very much for the information. I dive in over there.