Results 1 to 10 of 13
Thread: prop swap time
-
07-08-2020, 06:14 PM #1
prop swap time
Added 2 720 midship bags to a 2020 moomba max and finally got enough wave for me to surf....wife and kids could surf before ballast but i couldnt
so with 1000 each rear and 1000 under bow and another 1440 mid ship getting up to 11 mph with wife and too kids was tough with out adding alot of center plate. no way we get there with a full crew . talked with Eric at OJ props and he suggested to go to the 930 from the 932. was just looking to get some feed back from any of you guys who may have done this already and how its worked pulling top end ect..
-
07-08-2020, 06:29 PM #2
The 932 is a 15.5 x 16.5 whereas the 930 is a 15.5 x 15.25, the lower pitch should give you some more low end grunt without sacrificing too much top end speed.
Wakemakers has a performance guarantee for $50, if you aren't satisfied with the performance, you can swap it out.
You might also want to reach out to Acme for a prop recommendation. Shoot them an email with details like boat, motor, ballast and elevation. They get back pretty quick to you. [email protected]
If you end up going Acme over OJ, check out Nettle props....they seem to have the best Acme pricing and you get a gift certificate for $50 off prop repair w/ your purchase.
Sent from my Note 9 using Tapatalk2017 Moomba Craz Surf Edition
Flow 2.0 Surf System w/ AutoWake™
5,600 Lbs Ballast - Enzos + Lead + Sumo
Wet Sounds REV10s + REVO12-XXX
-
07-08-2020, 10:21 PM #3
I went with the acme 2419 to replace the oj “surf” prop. No complaints thus far
2018 Murder Max
2008 Outback V-Bought new; sold in 2018
-
07-09-2020, 06:30 AM #4
The Acme 2419 and 2937 were both reccomended for my Craz as improvements over the original OJ 945.
Since we primarily surf loaded down, in a region known for engine heat soak, I went with the 2937 15 x 11. It's a hole shot beast and surf RPMs are way lower. Definitely a great upgrade this season!
I don't have any massive lakes to cross so a little loss of top end was no concern to me.
Sent from my Note 9 using Tapatalk2017 Moomba Craz Surf Edition
Flow 2.0 Surf System w/ AutoWake™
5,600 Lbs Ballast - Enzos + Lead + Sumo
Wet Sounds REV10s + REVO12-XXX
-
07-09-2020, 08:59 AM #5
-
07-09-2020, 03:01 PM #6
prop swap time
What rpm and speed are you running with that RC?
Sent from my iPhone using Tapatalk2018 Max - Ultrablue flake/Gray - 4400 lbs water (720s midship), 750 lbs lead somewhere
-
07-09-2020, 08:09 PM #7
-
07-10-2020, 02:14 AM #82018 Max - Ultrablue flake/Gray - 4400 lbs water (720s midship), 750 lbs lead somewhere
-
07-10-2020, 12:35 PM #9
What prop do you have now?
I have 15x13 OJ 945 and it will get to surf speeds no problem with 4,770 lbs of ballast.
Getting to wakeboard speeds is a different story if doing a hole shot but we don’t wake board so not an issue. If we have to move spots while fully ballasted I just drain drain some out real quick from the rear bags. Otherwise it takes a bit to get to planing speeds. I haven’t tried Autowake for wakeboard set speeds to know if we get the “launch” feature where it not only drops center plate but also the surf tabs to help get the boat out of the water. I know Supras with Autowake does this but not sure if Moomba does.2019 Moomba Max "MOOMBAE"
Mods: Wakemakers upgrade + 500 lbs of lead
2016 Yamaha AR192 - sold
-
07-10-2020, 01:17 PM #102017 Moomba Craz Surf Edition
Flow 2.0 Surf System w/ AutoWake™
5,600 Lbs Ballast - Enzos + Lead + Sumo
Wet Sounds REV10s + REVO12-XXX