Drill Powered Oil Extractor

[rdlangston13]

I have been looking for was to increase speed and decrease the mess when doing oil changes on the boat and I came across this.

https://www.amazon.com/TOOLGUY-REPUB...cm_wl_huc_item

Anyone have one and if so, how do you like it? Looks like it may be perfect for the application in regards to all the fluid changes on the boat.

[larry_arizona]

I had a cheaper drill pump and it didn’t work on oil.

I highly recommend


OEMTOOLS Manual Extractor 24397 9.5 Liter Hand-Pump Evacuator | Extract Oil, Transmission, Coolant, Other Fluids Through Dipstick Tubes | No Need to Get Under Your Vehicle | No Mess, Easy to Use https://www.amazon.com/dp/B01BW393E2..._wA41EbE1M6R55

Mess free as it gets.


Sent from my iPhone using Tapatalk

[VA LSV]

I have the OEMTOOLS extractor and love it. I tried drill pumps and cheap battery powered pumps and the vacuum extractor is much quicker and easier.

[Snowslydder]

I have this guy and it works great and only takes like 15 pumps. My Craz fills it. I just detach the house and dump the the top half out in a container and then finish it off. Also use this for the tranny fluid and car oil changes now.

https://www.amazon.com/EWK-Pneumatic...%2C1071&sr=8-5

[BigOrange]

RD, I've tried both and like the other replies, go with the vacuum container extractor type. You won't regret it.

[sandm]

I have the pela and it works ok but if I was buying again I'd pick up the one posted above.
there have been several posts in the last 15 years on the drill based and almost everyone said back in the day buy the pela. the one above looks to be a nice improvement over that original vacuum pump.

[larry_arizona]

The OEM tools one is perfect for the raptors, it was the only one I could find to hold 8 qts+.

A few pumps, kick back with a cold beer and viola, done.

You will also need this......


Air hose fittings and Air Coupler... https://www.amazon.com/dp/B074SY2L13...p_mob_ap_share


Sent from my iPhone using Tapatalk

[rdlangston13]

I have a plea vacuum type. Thought that this may be an improvement to it since all the seals and such are shot on my pela. I’ll look at the OEM one


Sent from my iPhone using Tapatalk

[jimmsch]

I had a cheaper drill pump and it didn’t work on oil.

I highly recommend


OEMTOOLS Manual Extractor 24397 9.5 Liter Hand-Pump Evacuator | Extract Oil, Transmission, Coolant, Other Fluids Through Dipstick Tubes | No Need to Get Under Your Vehicle | No Mess, Easy to Use https://www.amazon.com/dp/B01BW393E2..._wA41EbE1M6R55

Mess free as it gets.


Sent from my iPhone using Tapatalk

Do you think it would be OK to use this while at the dock?

[larry_arizona]

Do you think it would be OK to use this while at the dock?

Absolutely


Sent from my iPhone using Tapatalk