Results 11 to 16 of 16
-
08-12-2020, 01:20 PM #11Junior Member
- Join Date
- Jun 2020
- Location
- Colorado
- Posts
- 17
Thanks jzelt. I just started working on this rig again. How you explained it is how I have it hooked so sounds like I have it correct.
bergermaister - I was actually planning to do something of that nature because the ol plunger fake a lakes never work all that well.
A new problem I have run into is the possibility this boat may of had a lanyard switch. I have no power to coil or any purple wires for that matter at the engine. I just put a new switch in and verified I have 12.6 volts with ignition on, but nothing at plug 5 on the engine to boat harness. I did find a hole under the shifter that has two blue wires dangling. Thinking this was the lanyard, but without a wiring diagram I have no way of knowing for sure.
-
08-12-2020, 09:36 PM #12Junior Member
- Join Date
- Jun 2020
- Location
- Colorado
- Posts
- 17
Update. Got the electrical fixed. It was the lanyard switch. It finally is alive.
-
08-12-2020, 10:02 PM #13
I’m impressed, cool project.
-
08-15-2020, 10:07 AM #14Junior Member
- Join Date
- Jun 2020
- Location
- Colorado
- Posts
- 17
I am looking for a zg46c transmission for this ride. Put it into gear for the time, no forward. Trans coming out today. Guess they don't sell a trans kit for this model.
-
08-20-2020, 06:08 PM #15Junior Member
- Join Date
- Jun 2020
- Location
- Colorado
- Posts
- 17
20200817_212841[1].jpg20200817_231727[1].jpg
More hydroturf on the Moomba forums. Bought some closeout material for cheap.
-
08-28-2020, 09:45 PM #16Junior Member
- Join Date
- Jun 2020
- Location
- Colorado
- Posts
- 17
20200828_144202.jpg
Got floor in today