Results 41 to 50 of 55
Thread: Under water lights
-
06-25-2020, 02:56 PM #41
Senior Member
- Join Date
- Jul 2019
- Posts
- 339
I ordered the 8k. It shipped today. I will let y'all know next week how it turns out
2019' Moomba Max
-
06-27-2020, 07:49 AM #42
Senior Member
- Join Date
- May 2018
- Location
- Waynesville, Ohio
- Posts
- 481
We were out later last night. Here is a better pic. It was pretty dark out in this one.
Sent from my iPhone using Tapatalk
2018 Moomba Craz
6.2L Raptor 400
6 Pump Ballast, Autowake 2.0, Flow 2.0 Surf System
OJ 15x13 Wake Prop
Digital Cruise Pro 3 (paddle wheel)
Wetsounds Rev 10's
2005 Supra Launch 22SSV - Sold
-
06-27-2020, 08:55 AM #43
Senior Member
- Join Date
- Jun 2013
- Location
- Naperville, IL || North Scott Lake, MI
- Posts
- 1,455
Ok, now that does look quite a bit brighter then the 10W that I have.
Mike
2013 Outback V
- ballast: 900# rears / 400# center / 650# IBS
- audio: Exile SXT9Q x 2 towers / Kicker KM65 x 6 cabins / Xi 12 sub / Javelin & XM15.4 amps / ZLD
- FAE
- DIY suckgate
2003 SeaRay 182 -- gone but not forgotten...
-
06-27-2020, 01:13 PM #44
Senior Member
- Join Date
- May 2018
- Location
- Waynesville, Ohio
- Posts
- 481
Yes, let us know. It didn’t look like that one would clear my wakeplate or I would have tried it. Would love to see a pic of the install to see if it would clear.
Originally Posted by DNIXD99
Sent from my iPhone using Tapatalk
2018 Moomba Craz
6.2L Raptor 400
6 Pump Ballast, Autowake 2.0, Flow 2.0 Surf System
OJ 15x13 Wake Prop
Digital Cruise Pro 3 (paddle wheel)
Wetsounds Rev 10's
2005 Supra Launch 22SSV - Sold
-
06-27-2020, 11:03 PM #45
Senior Member
- Join Date
- Jun 2013
- Location
- Naperville, IL || North Scott Lake, MI
- Posts
- 1,455
Finally got a pic of my 10W plug light - as you can see there isn’t much light coming from under the platform.....20W is definitely the way to go if you are thinking about this upgrade.
Mike
2013 Outback V
- ballast: 900# rears / 400# center / 650# IBS
- audio: Exile SXT9Q x 2 towers / Kicker KM65 x 6 cabins / Xi 12 sub / Javelin & XM15.4 amps / ZLD
- FAE
- DIY suckgate
2003 SeaRay 182 -- gone but not forgotten...
-
06-29-2020, 10:57 AM #46
Senior Member
- Join Date
- Feb 2017
- Location
- Colorado
- Posts
- 255
I had the 10, just got the 20 in. Will get a side by side pic to compare.
Sent from my iPhone using Tapatalk
-
06-29-2020, 01:37 PM #47
Senior Member
- Join Date
- Jun 2013
- Location
- Naperville, IL || North Scott Lake, MI
- Posts
- 1,455
Do you think you will be able to just swap out the light and the short section to the disconnect or are you planning to replace the whole wire? Originally Posted by jph3
Mike
2013 Outback V
- ballast: 900# rears / 400# center / 650# IBS
- audio: Exile SXT9Q x 2 towers / Kicker KM65 x 6 cabins / Xi 12 sub / Javelin & XM15.4 amps / ZLD
- FAE
- DIY suckgate
2003 SeaRay 182 -- gone but not forgotten...
-
06-30-2020, 09:32 AM #48
Senior Member
- Join Date
- Feb 2017
- Location
- Colorado
- Posts
- 255
Drivers look the same, wiring is the same otherwise so my plan is to swap it at the plug. Originally Posted by mikenehrkorn
-
06-30-2020, 10:43 AM #49
Senior Member
- Join Date
- Nov 2019
- Posts
- 165
The stern plug on my Helix is above the center plate it would seem the light would just shine on the plate and not light up the water. Does the light only light up the water if plate is at 100%?
-
06-30-2020, 11:15 AM #50
Senior Member
- Join Date
- Feb 2017
- Location
- Colorado
- Posts
- 255
Under water lights
This is the 10w when docked. Not sure what the plate level is...
Sent from my iPhone using Tapatalk
Reply With Quote