Results 1 to 3 of 3

Thread: Tower pin

  1. #1
    Join Date
    Oct 2015
    Location
    So. Cal.
    Posts
    21

    Default Tower pin

    Last time we were out on our 2015 Mojo with the tower that's not a S tower, one of the pins had moved out of the tower about 5/8". It's a pin in the front base of the tower. It seems the tower rotates on it when you lower the tower. We tried to move the tower up and down to get it back in, hammering with a hammer and a block of wood, using a large phillips, turning both left and right. We couldn't budge it. Has anyone had this issue, and how did you resolve it? Thanks.

  2. #2
    Join Date
    Jul 2015
    Location
    Melbourne, Australia
    Posts
    110

    Default

    Gidday Strato from OZ down under.
    Your boat is almost the same as ours colour wise, we've a white tower.
    We have a 2014 Mondo with the OZ HD tower and had that pin at the front base of the tower screw itself about halfway out early on.
    We had a difficult time getting back in but used a stainless steel ruler end that fit across the whole of the slot and with someone jiggling the tower around I managed to get it screwed in, did put a bit of locktite on the screw threads once I saw it beginning to move. So far so good, other side has been no probs, so far...…
    Hope that helps mate, it's Wintertime (almost) so twiddling my thumbs here.....enjoy the boating season.
    Cheers BruceR, Melb AUS.
    Last edited by bjrow; 05-23-2020 at 03:16 AM.
    Bruce
    2014 Moomba Mondo

  3. #3
    Join Date
    Oct 2015
    Location
    So. Cal.
    Posts
    21

    Default

    O.K. Thanks. Do you remember if it screwed in clockwise or counter clockwise?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •