Results 1 to 10 of 11
Thread: Moomba covers-tower socks
-
05-17-2020, 07:03 PM #1Junior Member
- Join Date
- May 2019
- Posts
- 14
Moomba covers-tower socks
Hi all,
Hope everyone is safe and enjoying some social distancing on the water. Question for everyone on covers. Our 2016 Craz cover has an opening that goes around the base of the tower on each side. We have a ton of trouble with water getting through this opening. I've seen several covers with "socks", for lack of a better term, that go up the tower a couple feet. I'm wondering if anyone knows where I can purchase these socks as I've had no luck in my searches. I'm worried that it's attached to the cover and ours simply doesn't have that built into cover. Thanks for the guidance as always friends!
-
05-18-2020, 09:15 AM #2
Might have to have them custom made
Sent from my iPad using Tapatalk2017 Moomba Craz
-
05-18-2020, 10:08 AM #3
Is there an option for a tower down full cover like Supra offers? If the tower folds, what is the advantage of leaving the tower up and covering the boat?
Sent from my iPhone using Tapatalk2021 Supra SA 400
2018 Supra SA 400 (SOLD)
Michigan
-
05-18-2020, 10:10 AM #4
No, as the Moomba towers do not lock in the lowered position and would bounce around like crazy.
Sent from my iPad using Tapatalk2017 Moomba Craz
-
05-18-2020, 11:49 AM #5
Thanks for clarifying Stazi, makes sense now.
Sent from my iPhone using Tapatalk2021 Supra SA 400
2018 Supra SA 400 (SOLD)
Michigan
-
05-18-2020, 11:50 AM #6
No worries, Kent.
Sent from my iPhone using Tapatalk2017 Moomba Craz
-
05-18-2020, 01:04 PM #7Senior Member
- Join Date
- Oct 2016
- Location
- Wisconsin
- Posts
- 311
i have never seen these but would be interested myself. The moomba covers are very hard to get tight around the base of the tower. Almost like they are quite a bit small. Even my dealer couldn't get it tight without gaps. This should be addressed by SC
2019 Mondo
-
05-19-2020, 11:54 AM #8Junior Member
- Join Date
- May 2019
- Posts
- 14
Thanks for the thoughts everyone. Looks like it's time to break out the sewing kit for some homemade socks.
-
05-19-2020, 10:58 PM #9Member
- Join Date
- Jun 2016
- Posts
- 41
We have had covers that had these as part of the design. As in all one piece.
I’ve been frustrated with covers that have a gap around the tower or Bimini—leaves and rain—more than you would expect.
-
05-20-2020, 05:32 AM #10
On my Mondo I ended up putting towels around the tower then put the cover over them. It wasn't a perfect seal, but it definitely helped.
IMG_4008.jpg
I was hoping not to with the newly designed cover, but it looks like I'll be doing the same with my Kaiyen.2020 Moomba Kaiyen > Finally on my lift!
2017 Moomba Mondo > Traded
2000 Moomba Kamberra > Traded