Results 1 to 4 of 4
-
03-09-2020, 12:42 PM #1
Removable Engine Panel Reinforcement
I know some of you have had to add additional reinforcement to the removable engine sidewall panels. Do any of you have pictures of what you have done? I am not talking about the aluminum track at the bottom, I already have that. I am still experiencing some bowing of the panel itself and was going to add a stiffener or two. Just curious what others are doing.
Sent from my iPhone using Tapatalk
2018 Moomba Craz
6.2L Raptor 400
6 Pump Ballast, Autowake 2.0, Flow 2.0 Surf System
OJ 15x13 Wake Prop
Digital Cruise Pro 3 (paddle wheel)
Wetsounds Rev 10's
2005 Supra Launch 22SSV - Sold
-
03-09-2020, 12:44 PM #2
This is the panel that I have. As you can see it already had some built in channels for reinforcement, but they are not enough.
Sent from my iPhone using Tapatalk
2018 Moomba Craz
6.2L Raptor 400
6 Pump Ballast, Autowake 2.0, Flow 2.0 Surf System
OJ 15x13 Wake Prop
Digital Cruise Pro 3 (paddle wheel)
Wetsounds Rev 10's
2005 Supra Launch 22SSV - Sold
-
03-09-2020, 01:25 PM #3
So my 2017 had the metal reinforcement channels on the panels themselves just like yours, I went ahead and added the Wakemakers panel saver kit to them as well.
On the engine side of the panels I also added Aluminum 'L' stock taller than the panel channel to keep panel from jumping track.
These mods keep my Enzos in check
Sent from my Note9 using Tapatalk2017 Moomba Craz Surf Edition
Flow 2.0 Surf System w/ AutoWake™
5,600 Lbs Ballast - Enzos + Lead + Sumo
Wet Sounds REV10s + REVO12-XXX
-
03-09-2020, 02:32 PM #4
Nice! Thanks. I will check out the panel saver kit.
Sent from my iPhone using Tapatalk
2018 Moomba Craz
6.2L Raptor 400
6 Pump Ballast, Autowake 2.0, Flow 2.0 Surf System
OJ 15x13 Wake Prop
Digital Cruise Pro 3 (paddle wheel)
Wetsounds Rev 10's
2005 Supra Launch 22SSV - Sold