Results 1 to 7 of 7
-
08-06-2019, 05:33 PM #1Senior Member
- Join Date
- Mar 2017
- Location
- Middle TN
- Posts
- 232
What are the 2 small wires on the outside of the tower?
Trying to figure out the wiring on the tower. The boat was not prewired for tower speakers but I do have wires that seem like they are for adding speakers attached to the rubber grommets.
There is a rubber grommet on the outside of the tower on each side on the bottom. It is attached to two small wires with what looks like a quick connector. It seems like it's too small to run speakers off of but I could be wrong what is it for?
Also, under the gunnel on the port side going to the amp there are two quick connects with wires that seem appropriate size for speakers. Is that what these are for?
Thanks!'18 mojo
-
08-07-2019, 10:45 AM #2Senior Member
- Join Date
- Oct 2013
- Location
- Ft. Collins, CO
- Posts
- 688
I'd guess the two small wires are for the all-around nav light.
2007 Mobius LSV
1989 Sanger Skier DX - sold
-
08-08-2019, 04:22 PM #3Senior Member
- Join Date
- Mar 2017
- Location
- Middle TN
- Posts
- 232
Makes sense that it might be a light wire just not sure why it's there and on both sides
'18 mojo
-
08-08-2019, 06:53 PM #4Senior Member
- Join Date
- Oct 2013
- Location
- Ft. Collins, CO
- Posts
- 688
Oh yeah, it doesn't make sense that wires for the light would be on both side.
2007 Mobius LSV
1989 Sanger Skier DX - sold
-
08-08-2019, 08:22 PM #5
IIRC, the anchor light uses gray and black color wires.
-
08-09-2019, 10:19 AM #6
Sent from my iPhone using Tapatalk2016 Mojo
-
08-09-2019, 10:21 AM #7
I believe all port wiring is for speakers. You should have been pre-wired for 4 tower speakers.
Sent from my iPhone using Tapatalk2016 Mojo