![Moomba on Facebook Moomba on Facebook](/assets/images/chicklet_facebook.gif)
![Moomba on Twitter Moomba on Twitter](/assets/images/chicklet_twitters.gif)
![Moomba on Vimeo Moomba on Vimeo](/assets/images/chicklet_vimeo.gif)
![Moomba on Instagram Moomba on Instagram](/assets/images/chicklet_instagram.gif)
![Moomba on Blogger Moomba on Blogger](/assets/images/chicklet_blogger.gif)
I recently upgraded my wheels and tires on my truck which lead me to think about increased potential for rock chips in the gel coat. For everyone with oversized tires, what are you using if anything to protect your boat while towing?
I run 35s on a negative offset wheel and my storage unit is mostly white caliche rock that like to get caught in the voids of my Nitto Terra Grapplers.
I use Rock Tamer flaps that attach to the hitch. It's highly adjustable in height and width.
These flaps do a great job keeping rock chips off the front of the boat.
Best part is they mount to the hitch so you don't have to drive around with them if you're not towing.
Sent from my Note9 using Tapatalk
2017 Moomba Craz Surf Edition
Flow 2.0 Surf System w/ AutoWake™
5,600 Lbs Ballast - Enzos + Lead + Sumo
Wet Sounds REV10s + REVO12-XXX
I have a set of rock tamers as well. good product BUT make sure you trim them to fit with the boat attached. I bought my set the night prior to towing 1800 miles to wisconsin and didn't realize that they were dragging when I hit a dip. I should have cut a few inches off them prior to mounting them on the crossbar.
if you use them in a snowy climate tho the 2 small bolts that secure to the hitch to keep it from moving will rust fairly easy. 1 trip into wisconsin in the snow/salt and I have some decent rust going on them. my only gripe.
'06 Supra Launch 20SSV-gone but never forgotten
X2 on the Rock Tamers
2018 Max - Wetsounds - Wake Makers upgrade
rock tamers here as well. Like Sandm said, make sure you trim them WITH the boat on the hitch. I made that mistake as well
Scott
2021 Craz
2007 Mobius LSV
1997 Sea Ray 190
Towtector for me. Does am awesome job of knocking debri down. Plus wiring harnesses can slip right through it to connect to the towing vehicle.
Sent from my iPad using Tapatalk
twkoehn
2007 Mobius LSV
1100s in rear lockers
750 lb IBS
Acme 1847
Has anyone used the mesh type with supports mounted to the trailer? Pictures still aren't working so I attached a link to what I'm talking about.
https://www.google.com/url?sa=i&rct=...62217902328384
Last edited by Skee907; 07-03-2019 at 01:29 AM.
- 1999 Moomba Outback LS/SK - 5.7 Indmar, Monster MT2 Tower, Kenwood Audio, Pyle Wake Tower Speakers
seen several discussions on that front thingey for the boat and my recollection are like larry's. expensive and does nothing for the trailer.
'06 Supra Launch 20SSV-gone but never forgotten
The 16 years I had my boat I never had a rock chip on the hull. My trailer was completely pitted on the fenders and axle and I repainted the fenders once. The angle of the hull is not much different than the direction of travel.
1998 Mobius
310 HP PCM
SOLD