2016 Moomba craz bow speaker wiring

[Craz16]

Hey guys,

My 2016 Craz did not come with front bow speakers and I have just bought some new kicker 6.5 4ohm to match the rest of my cabin speakers for the bow.

Now my question is, I looked underneath in the bow where the flat panel is where the speaker will be mounted, and there are two wires hanging down on both sides with connectors on them. Would these be pre wired speaker wires from the factory? The amp and other speaker wiring and receiver is all factory!

So I’m hoping I can just cut my speaker holes and connect the speakers to the wires that are already there.

Let me know if you have any insight on this. Thanks




Sent from my iPhone using Tapatalk

[Stazi]

Yep. Those are it. I did the exact same thing.


They route back to the cubby behind the observer seat.

I can’t remember if they were connected back to the head unit. But it did t matter as I added amps and a bunch of other stereo equipment.
Sent from my iPhone using Tapatalk

[Stazi]

Yep. Those are it. I did the exact same thing.


Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

[Craz16]

Yep. Those are it. I did the exact same thing.


They route back to the cubby behind the observer seat.

I can’t remember if they were connected back to the head unit. But it did t matter as I added amps and a bunch of other stereo equipment.
Sent from my iPhone using Tapatalk

Phew, perfect! I was hoping for that answer! Thanks guys!


Sent from my iPhone using Tapatalk