Results 1 to 2 of 2
Thread: Idle air bleed screws
-
06-05-2019, 11:17 PM #1Junior Member
- Join Date
- Jan 2014
- Posts
- 7
Idle air bleed screws
Doing some maintenance before I take the boat out after being in storage
I’ve always had a problem with starting the boat after being cold even when I try to start it up after being anchored.
I will start right up and i hold the rpms around 1k out of gear but sometimes as soon as I try to put it in gear and go it dies.
Then it takes a few times of doing the same thing and it gets going
If I do it quick enough I can get the boat going without dying but usually it’s in a no wake zone so I can’t gun it.
I’ve read that adjusting the idle air bleed screws can potentially help with idle issues.
Can someone point out if these are the correct screws to adjust? One on each side of the carb. Didn’t see any brass caps so I’m assuming someone previously had taken them out already
I’ve got a 2006 mobius lsv
Sent from my iPhone using Tapatalk
-
06-06-2019, 08:06 AM #2
Idle air bleed screws
There’s a TON of YouTube videos showing how to adjust the idle, accelerator pump and even how to swap air bleed screws if necessary. Google search “Holley idle adjustment”
Sent from my iPhone using TapatalkLast edited by Stazi; 06-06-2019 at 08:11 AM.
2017 Moomba Craz