Results 1 to 3 of 3
-
04-20-2020, 09:26 AM #1
HELP No Power to 1 Front Ballast Pump
20200420_080717.jpg
One of my front ballast pumps doesnt have power. I switched the connections, and both pumps are definitely working. Ive been working on the boat all weekend. From under the dash, all through the bow, to the amplifier. I added an amp, subs, and plumbed a bow bag. Im sure I knocked something loose
somewhere, or blew an inline fuse, if there is one.. What I need to know is how the wires run between the toggle switch and front pumps. Is there an inline fuse, ect.? Im going back today with a voltmeter, ect., and Im sure Ill find the problem, but it would be a lot easier if I knew how its laid out between the toggle switch and the pumps. Basically fill in the dotted lines on my crappy drawing.2019' Moomba Max
-
04-20-2020, 03:22 PM #2
-
04-21-2020, 10:15 AM #3
Yup was going to say there are 3 separate ballast relay modules that control the system. I had one of my modules go bad (port side module had a melt or short inside) last year. Had it replaced under warranty. Glad you got it fixed.
Last edited by haknslash; 04-21-2020 at 10:18 AM.
2019 Moomba Max "MOOMBAE"
Mods: Wakemakers upgrade + 500 lbs of lead
2016 Yamaha AR192 - sold