Raptor oil cartridge cap size -?

[Boonejeepin]

This is a bit of a lazy question as I should just do some trial and error to find the right size. What is the correct size socket or wrench to fit the Raptor motor’s oil cartridge cap? I don’t like how the adjustable and channel locks slip and mar the plastic.

Thanks!


Sent from my iPhone using Tapatalk

[Stazi]

I prefer, and use a rubber strap wrench instead.


Sent from my iPhone using Tapatalk

[Boonejeepin]

I prefer, and use a rubber strap wrench instead.


Sent from my iPhone using Tapatalk

Thanks. I’ll give that a shot. I am always a bit nervous that the composite plastic cap could break.


Sent from my iPhone using Tapatalk

[Stazi]

Thanks. I’ll give that a shot. I am always a bit nervous that the composite plastic cap could break.


Sent from my iPhone using Tapatalk

That’s why I’m not a fan of a regular hex wrench on it. Just put the strap wrench right near the top of the cap so it uses the stiffness of the cap to resist buckling, like it would if you put the strap around the middle of the body.


Sent from my iPad using Tapatalk