Results 1 to 3 of 3
Thread: Moomba speaker box replacement.
-
09-06-2021, 07:13 PM #1Junior Member
- Join Date
- Aug 2021
- Posts
- 4
Moomba speaker box replacement.
What do yall do to restore this part of your boat? Just recarpet or can i put vinyl there? I seen great lakes had some plastic pieces for it but i think their for the newer xlv models because i cant fine one with 5 cupholders. So shoot me some ideas. Prefer not to go back with carpet.
-
09-07-2021, 11:28 AM #2
Not sure how it's mounted in there. But if you went back with some vinyl that matched the Grey or red, I think it would look sharp. Black would be a good basic color too.
Sent from my SM-G781V using Tapatalk2021 Moomba Makai
Black Cherry Metal Flake & Fire Red
Nibral OJ 15.5x15 Altitude/Wake prop w/1.76 trans v-drive
Wet Sounds bow speakers & 10's on the Tower & ported sub
-
09-07-2021, 12:44 PM #3
iirc the moomba pieces were carpeted and supra were vinyl-ish panels. our '06 supra was vinyl-ish in those spots but the '07 lsv we looked at was carpet.
not sure what your budget or skill level is however for us, we would recarpet as if taken care of, should get a good 10+ years before showing any real signs of wear depending on hours use and carpet is a LOT easier than vinyl to do. vinyl would cost us money to have done and on an older boat, the ROI simply isn't there.
good luck with whichever way you go and post up pics of the progress... everyone loves good boat porn during the down time'06 Supra Launch 20SSV-gone but never forgotten