Page 2 of 12 FirstFirst 1234 ... LastLast
Results 11 to 20 of 114
  1. #11
    Join Date
    May 2018
    Location
    DFW, Texas
    Posts
    167

    Default October 2018 Picture Thread

    Season in North Texas still holding...lake is in the 70s and dropping though :/

    Finally found a buddy who is goofy so I could try setting up the starboard wave...lip is less clean, any Max owners know how to clean the lip? Is it all just in the tabs or does it look decent enough?



    Sent from my iPhone using Tapatalk
    2018 Max - Ultrablue flake/Gray - 4400 lbs water (720s midship), 750 lbs lead somewhere

  2. #12
    Join Date
    Jul 2011
    Location
    Murrieta, CA
    Posts
    1,590

    Default

    Quote Originally Posted by FamilyMan View Post
    Season in North Texas still holding...lake is in the 70s and dropping though :/

    Finally found a buddy who is goofy so I could try setting up the starboard wave...lip is less clean, any Max owners know how to clean the lip? Is it all just in the tabs or does it look decent enough?



    Sent from my iPhone using Tapatalk
    To clean up the lip you usually need to create more list. You can try to deploy the surf tabs further down but at some point you will loose power. Or, you can drain a little offside weight if moving people is not an option.


    Sent from my iPhone using Tapatalk
    2018 Max with a little extra weight here and there

  3. #13
    Join Date
    Aug 2017
    Posts
    1,382

    Default

    Buy a bit more lead and put it on the Surfside!


    Sent from my iPhone using Tapatalk

  4. #14
    Join Date
    Jul 2011
    Location
    Murrieta, CA
    Posts
    1,590

    Default

    Quote Originally Posted by dakota4ce View Post
    Buy a bit more lead and put it on the Surfside!


    Sent from my iPhone using Tapatalk
    Lead is always a great answer!


    Sent from my iPhone using Tapatalk
    2018 Max with a little extra weight here and there

  5. #15
    Join Date
    Jun 2018
    Location
    Kuna, Idaho
    Posts
    146

    Default

    Quote Originally Posted by FamilyMan View Post
    Season in North Texas still holding...lake is in the 70s and dropping though :/

    Finally found a buddy who is goofy so I could try setting up the starboard wave...lip is less clean, any Max owners know how to clean the lip? Is it all just in the tabs or does it look decent enough?



    Sent from my iPhone using Tapatalk
    That looks longer and cleaner than ours.
    2018 Max - Wetsounds - Wake Makers upgrade

  6. #16
    Join Date
    Jun 2018
    Location
    Kuna, Idaho
    Posts
    146

    Default

    Quote Originally Posted by Broke Pilot View Post
    What happened to that poor board? Lol I’d like to see a video of that
    Honestly I do not know.. could have just failed from use over time.. My husband was surfing and said he hit a fish, which none of us believe. He said he felt a big thump (I think that is when the board broke) then when he got up the next time it was bowing and cracked. I had just taken my run and the board felt funny but I thought that was just me. There was no wood or anything in the water.
    2018 Max - Wetsounds - Wake Makers upgrade

  7. #17
    Join Date
    Jun 2018
    Location
    Kuna, Idaho
    Posts
    146

    Default

    Quote Originally Posted by RC_Hinojosa View Post
    A little peek at my GatorStep project...

    I just have my sundeck walkthrough and swim platform left.

    **PRO tip, get the 3M adhesive remover wheel**

    Some pieces pulled right off without leaving any adhesive behind, the pieces that did, had a membrane over the adhesive that made acetone and mineral spirits useless.

    p.s. the wheel WILL fling sticky adhesive boogers EVERYWHERE.

    Sent from my SAMSUNG-SM-G935A using Tapatalk
    That looks amazing!!
    2018 Max - Wetsounds - Wake Makers upgrade

  8. #18
    Join Date
    May 2018
    Location
    DFW, Texas
    Posts
    167

    Default October 2018 Picture Thread

    Quote Originally Posted by Boonejeepin View Post
    To clean up the lip you usually need to create more list. You can try to deploy the surf tabs further down but at some point you will loose power. Or, you can drain a little offside weight if moving people is not an option.


    Sent from my iPhone using Tapatalk
    Totally forgot about my lead (thanks Dakota and Boone) all on the port side I use to offset the driver as my whole family is “normal” and usually it’s just me and the wife (recently she has been flaking and she would rather do home improvement crap, so hitting the buddies up to pull me, I have the whole of winter to do home improvement, right!?)

    Will pull that lead out and swap that around as it’s easier and more advantageous than constantly filling and dumping ballast as we switch side to side when I take goody folks out.


    Sent from my iPhone using Tapatalk
    2018 Max - Ultrablue flake/Gray - 4400 lbs water (720s midship), 750 lbs lead somewhere

  9. #19
    Join Date
    Jun 2008
    Location
    Henderson, NV
    Posts
    7,028

    Default

    Quote Originally Posted by Kxmoomba View Post
    My husband was surfing and said he hit a fish, which none of us believe.
    if ur surfing lowell, I would believe that all the way..... peak, black canyon or cj, no way
    lowell has some stupid big fish, and by that I mean they are big and they are stupid....
    '06 Supra Launch 20SSV-gone but never forgotten

  10. #20
    Join Date
    Jan 2017
    Location
    Katy, TX
    Posts
    1,678

    Default

    Quote Originally Posted by Kxmoomba View Post
    That looks amazing!!
    Thanks!! It's a brand new color from GatorStep called Electric Blue.


    Sent from my SAMSUNG-SM-G935A using Tapatalk
    2017 Moomba Craz Surf Edition
    Flow 2.0 Surf System w/ AutoWake™
    5,600 Lbs Ballast - Enzos + Lead + Sumo
    Wet Sounds REV10s + REVO12-XXX

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •