Raptor 400 oil drain hose cap size

[jmvotto]

Looking for the size of the oil drain hose cap so I can add it to the extractor to change the oil ?

My first guess is 1/4 npt female

[KnoxMojo]

With the unit from West Marine, I simply inserted the evacuator tube down inside the oil drain hose and sucked it out. Didn't spill a drop.

[jmvotto]

I have one thought I needed to create a vacuum seal but I guess that should work

Now which oil for it 5w30 syn blend ?

[KnoxMojo]

I have one thought I needed to create a vacuum seal but I guess that should work

Now which oil for it 5w30 syn blend ?

I use moto-craft 5w30 syn blend on the Raptor, not sure what yours calls for. With the tube, it was a snug enough fit, plus when you begin to pump, it creates the vacuum.

[jmvotto]

I use moto-craft 5w30 syn blend on the Raptor, not sure what yours calls for. With the tube, it was a snug enough fit, plus when you begin to pump, it creates the vacuum.

you heat it up at all?

[rdlangston13]

1/4” NPT female is correct. I just did this exact thing Monday. Worked very well.

Also, by using the fitting on the hose you are able to use the full 1/4” diameter of the hose instead of the smaller ID of whatever hose will inside there. Mine drained super fast with the Pela 6000 using this method.


Sent from my iPhone using Tapatalk