Wake Plate motor

[DOCDRS]

09 electric wake plate not working. Late to putting boat in water this year and it seems wakeplate is not functioning. Tge fuse was triggered so I reset it but to no avail. Before I did into it though I thougt I would reach out for any suggestions. Gauges all seem to work, the column lever does nothing, so , I will look here first, but have had no issues in 9 years with it. So either motor pooched over winter or loose corroded electical connection somewhere.

[DOCDRS]

Up date...... pulled deutsh connector at rear of boat apart and applied 12v to leads and nothing happend so I pulled actuator off and took it apart. There was water intrusion into the top motor area and corrosion visible inside. Ordering new actuator......my 2EEC5 part number doesnt correspond to any part number but I believe it 15122-001 and am confirming with Lenco

[Shoebox]

Up date...... pulled deutsh connector at rear of boat apart and applied 12v to leads and nothing happend so I pulled actuator off and took it apart. There was water intrusion into the top motor area and corrosion visible inside. Ordering new actuator......my 2EEC5 part number doesnt correspond to any part number but I believe it 15122-001 and am confirming with Lenco

This is the Lenco ID chart.

[DOCDRS]

But the 5 at the end corresponds to nothing. The above are for theirgeneric actuators , they have anothe chart for ski boats but nothing coresponds as well. I do believe they are a short 1.25" throw as well

http://www.lencomarine.com/index.php...9c1328e507e854


IMG_0962.jpg

[Shoebox]

I have been having trouble with my wake plate as well, so I'd been looking up the actuator #. My code is different than yours (7L1H4), but it's 1.25" stroke and at the time I also came up with the 15122-001. Are you sure the 2nd letter is E?

Check the mounting hole sizes and you should be able to confirm.

http://www.mmimarine.com/mmi/index.p...prod_id=586480

[DOCDRS]

I am 100% sure
image.jpg
I pulled the other business end off and the screw part is fine so I know it is the motor, plus there was water in it as well. I'm thinking where the wire comes in may have leaked or maybe at the ram. Had to determine. I emailed Lenco just to confirm but this is the one they have listed in there ski boat category for Supra moomba skiers choice

[Shoebox]

It's interesting that neither chart really addresses your code. The chart you listed confirms mine is the 15122-001.

[DOCDRS]

It's interesting that neither chart really addresses your code. The chart you listed confirms mine is the 15122-001.

Yes, Lenco is saying mine is different, BUT, my end or Ram hole is 3/8" and I just confirmed the ram throw to be 1.25 " so mine has to be 15122-001 as well as this is the only one with a 3/8" hole. Otherwise I would have to drill out the 5/16 to 3/8.

[DOCDRS]

Update.....just got another email from Lenco confirming I am right and it is 15122-001.

[Shoebox]

Update.....just got another email from Lenco confirming I am right and it is 15122-001.