Results 1 to 9 of 9
Thread: Wake tower rubber
-
06-12-2018, 07:50 PM #1Junior Member
- Join Date
- Aug 2016
- Location
- Sellersburg, Indiana
- Posts
- 4
Wake tower rubber
I have an 07XLV, I am wanting to replace the rubber between tower and boat. Any suggestions?
-
06-12-2018, 10:22 PM #2
I did this a couple of years ago on my 07 LSV. Bought some rubber mat about 3/8 thick from Peavey Mart ( but you can get it from any store). Taking the bolts out was a PITA, but once you have it raised a bit, you can trace it out, cut a hole in the middle for the wires and a small cut to from the side to the middle to slide it in. Tighten it down and repeat 3 more times. Took more time getting the nuts off that installing the new rubber.
2016 Craz
2007 LSV - Sold
2003 Outback - Sold
-
06-12-2018, 10:58 PM #3
Lots of folks used to buy "pads" from dealer but later it got much more common to make your own. Hopefully some guys chime in on what source they used as this is a fairly common and not too difficult job you can do yourself.
My Mom said I'm not allowed to get wet!
2008 LSV (sold)
2000 Outback LS (sold)
LLTR!!!!!!!!
-
06-13-2018, 01:05 PM #4
I've used leftover hydroturf in a pinch. it only lasts about a season, but I have plenty of leftover and it's cheap and easy.
2008 Moomba Mobius XLV. Monster Cargo Bimini, WS Rev 410's, Polk Cabins, 3 Infinity Subs, PPI amps, WS420, Exile BT, upgraded ballast pumps, up to 3,500+ pounds of ballast, Blue LED's...
1992 Supra Sunsport. **SOLD** 2k pounds ballast, Surf System, Blue LED's everywhere, decent audio system.
Tow Rig: 2013 F150 Ecoboost FX4 (wife's rig) Other money pits include:1998 BMW M3 Cabriolet, 2009 Audic A6 Avant 3.0T, 2005 Kawasaki ZX-6R 636.
www.TraysonsToybox.com
-
06-13-2018, 02:48 PM #5Senior Member
- Join Date
- May 2016
- Location
- West Milwaukee, WI
- Posts
- 283
Do all towers have these pads? I don't see anything at the base of my tower, and it's pretty snug and tight.
2004 Mobius LS - hooked on footin'
Former tow: 1986 Chaparral 178 XL, 90hp Merc
First tow: 197x Glasspar Citation, 135hp Merc
-
06-13-2018, 03:33 PM #6
Bsharer be the guy to ask he just replaced his this season
Sent from my iPhone using Tapatalk2015 Mojo
2005 Yamaha at-230 sold
2012 Ram 2500 tow rig
-
06-13-2018, 08:37 PM #7
We found that the roof vent flanges you can buy from home depot for $10 have a good amount of rubber you can use for something like this. Used it to replace aging speaker bracket rubber.
2021 Mojo, 6.2L Raptor 400/1.76, Acme 3407 15.5x13, G6, Flow3, +6500 lbs ballast
2005 Mobius LSV (sold)
Windermere Lake, B.C., 2800' Elevation
2021 Mojo Mods
-
06-13-2018, 11:42 PM #8Senior Member
- Join Date
- Aug 2015
- Location
- Spokane, WA
- Posts
- 262
Wake tower rubber
Contact Andrew at Bakes [email protected]. He ordered me replacements for dirt cheap. Skiers Choice no longer uses the black rubber ones. The new and improved version is a clear vinyl; kinda like that clear vinyl tubing.
Sent from my iPhone using Tapatalk Pro2008 Moomba Mobius LSV
-
06-17-2018, 08:27 AM #9Junior Member
- Join Date
- Aug 2016
- Location
- Sellersburg, Indiana
- Posts
- 4
All of these are great ideas. Thank everyone.