Results 1 to 10 of 15
-
05-29-2018, 06:35 PM #1
New 2018 Craz and the water temp and Fatho dont work.
I contacted the dealership and they said they are looking into it but I am going to have to drive 2 hours plus seattle traffic(good luck changing lanes) with a boat to get it fixed when they call back. Have any of the awesome people of this forum seen this before
-
05-30-2018, 08:55 AM #2Senior Member
- Join Date
- Jan 2018
- Location
- Lexington, KY
- Posts
- 369
Mine is exactly the same. Do you have GPS for Speed? I do. And I think it may be related. My dealer is also checking into it. I'm giving him a little slack on this one, because it doesn't affect me much and I know that they're slammed delivering boats for spring. This weekend I figured out why my starboard side ballast was filling and draining much slower than the port side. While draining ballast I happened to open the engine hatch, and saw water spewing down the inside of the transom. Once enough water was out of the bag, I removed the trim panel at the rear of the starboard locker, and found one of the screws that attaches that panel run directly into the fill drain hose between the Y and the through-hull. A little duct tape got me through the weekend, but that one I'm a little more Furious about...
20180513_195959.jpg2018 Moomba Craz | Autowake 2.0, Zero-Off, G6 Pumps | Captain Blue/Dark Graphite/Silver Flake | Enzos + Lead
-
06-01-2018, 01:22 PM #3Junior Member
- Join Date
- Feb 2018
- Posts
- 12
My water temp doesn't work after alternator replacement. 4 hours on boat, looking for solution as well
Kyle
2018 Craz
-
06-01-2018, 02:12 PM #4
I have 16 hours on my 2018 Craz. I have not had the alternator issue or noticed any voltage drop, but I do have a whining sound just above idol speed. I suppose that could be the alternator making that noise. Did either of your experience that sound?
2018 Moomba Craz
6.2L Raptor 400
6 Pump Ballast, Autowake 2.0, Flow 2.0 Surf System
OJ 15x13 Wake Prop
Digital Cruise Pro 3 (paddle wheel)
Wetsounds Rev 10's
2005 Supra Launch 22SSV - Sold
-
06-02-2018, 12:20 AM #5
I am still waiting for a reply about the dash board, I feel like it should be fixed for free since it is brand new.
2018 Craz, 3000lbs stock ballast, ENZOs, 500lb Lead Ballast, Still chasing the best wave!
-
06-02-2018, 09:08 AM #6Senior Member
- Join Date
- Jan 2018
- Location
- Lexington, KY
- Posts
- 369
Oh, it absolutely will be fixed for free! My dealer says that there is a connector they've seen loose before that causes this. But on the 2018 they moved the front pumps to the front, and block access to that connector. They're waiting for ideas from skiers choice on what to do.
2018 Moomba Craz | Autowake 2.0, Zero-Off, G6 Pumps | Captain Blue/Dark Graphite/Silver Flake | Enzos + Lead
-
06-07-2018, 10:55 AM #7
and the weighting games begin. I guess I will stay out of new lakes until this is fixed
2018 Craz, 3000lbs stock ballast, ENZOs, 500lb Lead Ballast, Still chasing the best wave!
-
06-07-2018, 11:43 AM #8
-
06-10-2018, 10:34 PM #9Senior Member
- Join Date
- Jan 2018
- Location
- Lexington, KY
- Posts
- 369
Talked to my sales guy this weekend and he said the factory recommend replacing the Paddlewheel. I guess the depth and temp sensor is built into that. I have GPS Cruise, so no clue if the Paddlewheel itself was working. Side note: does anyone know if there's a way to toggle over to Paddlewheel mode when you have GPS?
Dropped the boat off on the way home from the lake tonight. They're fixing up a couple other little things at the same time; leaking ballast hose, troubleshoot a bad brake/turn signal, and maybe adjusting some interior parts, because my bow filler doesn't quite fit right and I'm concerned with it rubbing a hole in the adjacent seat back. Then of course doing the first service! I'll update this thread on the paddlewheel fix!
2018 Moomba Craz | Autowake 2.0, Zero-Off, G6 Pumps | Captain Blue/Dark Graphite/Silver Flake | Enzos + Lead
-
06-11-2018, 04:16 PM #10Senior Member
- Join Date
- Jan 2018
- Location
- Lexington, KY
- Posts
- 369
So, my guy just called and said that my boat was built without the right sensors! I'm still a little fuzzy on who was wrong, the dealer, or the factory, but my option for depth and temperature was never added! He's got the parts in stock, and supposedly adding it on for me to pick up by the end of the week.
I guess maybe that's a place for you to start looking.2018 Moomba Craz | Autowake 2.0, Zero-Off, G6 Pumps | Captain Blue/Dark Graphite/Silver Flake | Enzos + Lead