Results 11 to 20 of 26
Thread: Prop change
-
05-09-2018, 01:00 PM #11
Prop puller worked fine. The hardest part was getting the cotter pin out. I had to beat it out with a crescent wrench and a screw driver. Hopefully I got it back together the right way and the shaft is ok. I hit the rudder a few times, but my main concern was the prop shaft vibrating the whole time I was trying to get the pin out. Oh well I guess we will see today. Also, can you reuse the nylon locknut? I am thinking about removing the prop again to make sure the keyway is not on the sloped part of the shaft putting the prop in a bind. It seems kind of loose after tightening. Plus I need to remove to torque properly. I am scared I may have over tightened the nut.
2017 Moomba Mondo
1120 rear lockers
500 center hard tank
750 ibs
2-650s in the floor
Acme 2079 prop
-
05-09-2018, 01:08 PM #12
Also, does anyone know where I can buy a box of cotter pins online? I would like to keep extras instead of going to dealer everytime I need one.
2017 Moomba Mondo
1120 rear lockers
500 center hard tank
750 ibs
2-650s in the floor
Acme 2079 prop
-
05-09-2018, 01:19 PM #13It seems kind of loose after tightening.
You can order prop nut kit that comes with a nut, key and pin.
On a 2017 boat, yeah no issue reusing the nut.
-
05-09-2018, 02:33 PM #14
Mcmaster carr for cotter pins/extra hardware.
2011 Mobius LSV
2005 Mobius LS (sold)
-
05-09-2018, 03:25 PM #15
-
05-09-2018, 03:27 PM #16
-
05-09-2018, 05:34 PM #17
What sizes should I look for?
Sent from my SM-G955U using Tapatalk2017 Moomba Mondo
1120 rear lockers
500 center hard tank
750 ibs
2-650s in the floor
Acme 2079 prop
-
05-09-2018, 05:37 PM #18
-
05-10-2018, 10:18 AM #19
You could sell them all day for $50.
http://www.skidim.com/ACME-PROP-PULL...ductinfo/228S/
https://www.bakesonline.com/prop-pul...op-puller.htmlMy Mom said I'm not allowed to get wet!
2008 LSV (sold)
2000 Outback LS (sold)
LLTR!!!!!!!!
-
05-10-2018, 10:37 AM #20
Clever homemade tool, I really like it. Well done.
But honestly you have easily an hour or two of labor into that I am sure, plus the actual c clamp cost.
$90 pro tool is not that expensive.
Sent from my iPhone using Tapatalk2021 Supra SA 400
2018 Supra SA 400 (SOLD)
Michigan