Results 11 to 20 of 47
Thread: Underwater LED install
-
04-30-2018, 09:11 AM #11
Wish I would have known this a couple years ago, I ran my own lines, lol.
2018 Supra SA400 aka The Ron Burgandy
2011 Sea-Doo Wake 155
2015 Mojo Surf, sold...2013 Axis A22 Recon Edition, sold...2010 Axis A22, sold...2007 Maxum 1800sr3, sold
-
04-30-2018, 10:00 AM #12
-
05-02-2018, 04:15 PM #13
-
05-08-2018, 05:09 PM #14Junior Member
- Join Date
- May 2018
- Location
- Lake Lanier
- Posts
- 8
how is the light any pics?
-
05-08-2018, 05:17 PM #15
What the heck. Their whole sales pitch was that it works without interfering with the wakeplate. Mine is still in the box. I had my work cut out for me fishing out the fogging straw that I shot into one of my cylinders when I winterized in the fall. That's 7 hours of my life I'll never get back....
Sent from my SM-G930W8 using Tapatalk2016 Craz.
Enzo bags.
-
05-08-2018, 07:19 PM #16
Maybe on all the other boats, but the fact is our drain plug is way to close to the wake plate. I modified it in 5 minutes on my mini belt sander. I had to take breaks and cool it off a few times as the bitch gets hot grinding it and I didn’t want to screw up the LEDs by getting them too hot. The manufacturer even says do t leave them op out of the water if they will burn out. I tested them for 30 seconds a coupe of times as I was wiring them up and it was fine. There a bunch of wires that need solder g so o wanted to be sure it was all good before I glued the bitch in!
Sent from my iPhone using Tapatalk2017 Moomba Craz
-
05-09-2018, 03:48 PM #17Junior Member
- Join Date
- May 2018
- Location
- Lake Lanier
- Posts
- 8
so i contacted customer service and sent them a pic of the drain plug per there request... they said the mormo should fit without modification. i ordered one. i will update after i install it.
-
05-09-2018, 05:10 PM #18
-
05-14-2018, 12:45 AM #19
-
05-14-2018, 05:32 AM #20