1450’s

[Edo88]

Finished it today.

What i ended up doing is...

Reference the pictures. The stock vent hose has a lot of extra tubing so i cut off about 14 inches and used that to replace the small tube which took the fitting to the motor side connection. And then re clamped the vent line. Pretty easy aside from heating and getting the hose connections done. Which was a pain cramped up in the compartment like that...

Stock hose for center connection


Stock vent line


New connection


New vent line

Awesome I’ll just do that thanks


Sent from my iPhone using Tapatalk

[MJHSupra]

Stock hose for center connection

What is the pump mounted to? Looks like you remove those 4 screws to remove the pump to change the impeller?


Sent from my iPhone using Tapatalk

[c04rsx-sm]

What is the pump mounted to? Looks like you remove those 4 screws to remove the pump to change the impeller?


Sent from my iPhone using Tapatalk

It is just mounted to an hdpe type plastic board that holds the pump and connections. And yes just 4 bolts and you can move the pump enough to get the impeller out to Change. Might not even need to take the pump off...

[jnr4817]

Just picked up a used 2018 mojo that came with enzo's already. Going to do this mini-mod. Thanks for the write up.

[Craz16]

I have the exact fit Mojo bags, they are 1270lbs each. With our discount I think they were close to $900 with all new fittings.

What’s our discount code for WM??


Sent from my iPhone using Tapatalk

[jnr4817]

I finally had a chance to complete this and the previous owner had used a t fitting to split the connection for fill/drain on both sides of the bag of the enzos. I moved the vent hose to the location you used. Any issues with splitting the single bottom fill/drain hose into 2?