Results 1 to 7 of 7
-
03-31-2018, 11:40 PM #1
05 LSV gravity III upgrade problems...
I can't get the 90 degree street tee off the intake scrupper. I have the scrupper loose and ready to drop out but can't until the thru hull nut comes off, and the street 90 is in the way. Its acts like it is bonded on there, not to mention the lack of room to work with.
Any suggestions on how to get it off?
Sent from my SM-N950U using Tapatalk2005 Mobius LSV GG3 Package w/ Acme 1433
325 Indmar MPFI
Ballast: 750s Rear, 400 Center, 2 spare 260s
Kenwood KMR-440U
Wetsounds WS-420
JL M600/6 on 6 Polk MM6501UMs
JL HD750.1 on a Kicker L7 10"
JL HD600.4 on Kicker 6500.2 HLCDs
-
04-01-2018, 08:13 AM #2
-
04-01-2018, 12:21 PM #3Senior Member
- Join Date
- Oct 2013
- Location
- Ft. Collins, CO
- Posts
- 688
Leave it and just start plumbing to it. I think that they might be using 3M 5200 or similar on the threads. The 90 wasn't ideal when I redid ours but it's not so bad that I'd invest any significant time to redo. Even if you want larger fittings, one smaller fitting isn't going to make much difference (the diameter of the hose will have a much bigger impact).
2007 Mobius LSV
1989 Sanger Skier DX - sold
-
04-02-2018, 09:18 PM #4Senior Member
- Join Date
- Aug 2011
- Posts
- 2,522
http://www.instgram.com/jlyons30
2002 Moomba Mobius LSV - Sold
2006 Moomba Mobius LSV - Sold
2017 Moomba Craz - Enzos, Lead
-
04-03-2018, 02:30 PM #5
The stock one was too tall for what I was doing and was a 90* on mine. Every 90 kills water flow a bit. I cut it off with an angle grinder in seconds. I tried heat along with pipe wrenches, sprays, someone holding underneath and nothing budged. Cut that bad boy off.
2007 XLV Gravity Games
Full Wake Makers upgraded ballast and pumps
1,100 in each rear locker
1,180 in front
OJ 1435 prop, 325 EFI Indmar Assult.
Fresh Air Exhaust
SuckG8
Bunch of other crap
-
04-06-2018, 09:39 PM #6
I am committed at this point, as the intake is dangling. I'm not sure if I can get it resealed without getting it completely off.
Sent from my SM-N950U using Tapatalk2005 Mobius LSV GG3 Package w/ Acme 1433
325 Indmar MPFI
Ballast: 750s Rear, 400 Center, 2 spare 260s
Kenwood KMR-440U
Wetsounds WS-420
JL M600/6 on 6 Polk MM6501UMs
JL HD750.1 on a Kicker L7 10"
JL HD600.4 on Kicker 6500.2 HLCDs
-
05-05-2018, 12:15 PM #7Senior Member
- Join Date
- Aug 2015
- Location
- Spokane, WA
- Posts
- 262