New Prop, FAE and custom sub enclosure 2016 Craz

[mcjimmy33]

Installed a new prop, FAE and sub enclosure for my Craz this weekend. Was a ton of work and I cant wait to get out and test them all. Forgot to take a picture of the sub installed, will grab that in the next week or so. For anyone installing the FAE, i found tying a rope to a tightened down to a hose clamp was the best way to remove the baffle from the boat. I routed the rope through the exhaust flange and pulled through the exhaust hole.

FAE.jpgnew prop.jpg

[Stazi]

Thanks for the tip. I need to install mine in the spring.


Sent from my iPhone using Tapatalk

[Stazi]

Did you use debond on the old exhaust flange glue? Can you post pic of that bottle or tell me which brand you used? I need to get some.


Sent from my iPad using Tapatalk

[mcjimmy33]

Yes I used Debond, I bought the install kit from fae. Bottle looked just like this. I used the back side of a claw hammer to pry the flange off after spraying the debond. Just make sure to put a towel where the hammer contacts the boat.

http://www.fawcettboat.com/pc_produc...iABEgKsY_D_BwE


Sent from my iPhone using Tapatalk

[RC_Hinojosa]

How many hours to do the FAE install? Is it like a Saturday afternoon with a buddy & a sixer?

[mcjimmy33]

I would say it took me and a buddy about 4, maybe 5 hours, including changing the baffle. The baffle removal was at least 1/2 this time untill we found a good method to get it out. The FAE install took about an hour, the rest of the time is removing the old components.


Sent from my iPhone using Tapatalk