Results 51 to 60 of 78
Thread: Surf tab or gate?
-
02-06-2018, 07:16 PM #51Member
- Join Date
- Mar 2017
- Posts
- 57
There are no limit switch and the freewheel at the end so no amperage changes. That’s the tough part is one timing the actuator and two turning on a lighted switch that stays on while deployed.
Last edited by Hyperryd; 02-06-2018 at 07:20 PM.
-
02-06-2018, 07:21 PM #52
So is it possible to change the timing?
2019 Supra SL450
-
02-06-2018, 07:33 PM #53Member
- Join Date
- Mar 2017
- Posts
- 57
I can set it in one second intervals. They can be changed later but it is complicated.
If It Was Easy Everybody Would Do It!
-
02-06-2018, 09:01 PM #54
Got the template almost worked out. The lower section of the hull is about 6.5 inches, and the nice thing is it's flat, so no spacer needed. Hinges can mount flat to the boat.
The vertical angle seems good, so I need to take my angle finder to be able to replicate it on the other side.
I can trim a hair off the top and it will sit flush with the top of the swim step , and I could add maybe 1/2" to the lower rear to get a little more in the water when it's extended.
Hyperryd, how far in from the edge of the boat did you mount yours?2019 Supra SL450
-
02-06-2018, 09:09 PM #552019 Supra SL450
-
02-07-2018, 12:11 PM #56
Mount them in 1"
Sent from my SM-G930V using Tapatalk-Jake
-
02-07-2018, 12:34 PM #57
-
02-07-2018, 01:02 PM #58
Yes yours is more complicated than mine. The goal was to match the angle of the hull and be back 1". But I was working with a straight line.
Sent from my SM-G930V using Tapatalk-Jake
-
02-07-2018, 01:06 PM #59
Nothing's ever easy.
2019 Supra SL450
-
02-07-2018, 06:02 PM #60Member
- Join Date
- Mar 2017
- Posts
- 57
Cough,signature,cough,cough
If It Was Easy Everybody Would Do It!