Results 31 to 40 of 78
Thread: Surf tab or gate?
-
02-01-2018, 06:10 PM #31Member
- Join Date
- Mar 2017
- Posts
- 57
Lenco 15129-001 4 1/4" stroke fast actuator - 12 volt - 5/16"
-
02-01-2018, 06:21 PM #32
Perfect thanks
2019 Supra SL450
-
02-01-2018, 08:22 PM #33
Well you just about had me sold on doing gates. I cut out some cardboard templates and headed down to the marina where my boat is stored.
Because of the lines on my boat, I don't think the gates are going to work, unless I use a huge spacer block for the lower hinge.
Looks like I need to start saving for the Wakelogic controller...
2019 Supra SL450
-
02-01-2018, 08:33 PM #34
Cut the hdpe to fit the contour
Sent from my SM-G930V using Tapatalk-Jake
-
02-01-2018, 10:04 PM #35
-
02-01-2018, 10:37 PM #36Senior Member
- Join Date
- Aug 2017
- Posts
- 1,382
-
02-01-2018, 10:42 PM #37
-
02-01-2018, 11:07 PM #38Junior Member
- Join Date
- May 2017
- Location
- Amarillo, TX
- Posts
- 19
You can get 4” and 5” tall stainless hinges and just run the one is what he is referring to. And the end of the actuator will twist so if the angle tries to change some it will be ok to a point. If too much the load on the actuator will pop the fuse.
Sent from my iPhone using Tapatalk
-
02-01-2018, 11:08 PM #39Member
- Join Date
- Mar 2017
- Posts
- 57
Nothing new to see here...386766.jpgaxis-a20-stern.jpg
-
02-01-2018, 11:12 PM #40Member
- Join Date
- Mar 2017
- Posts
- 57
Just practice on the Nautique parked next to you. Practice makes perfect.