Results 11 to 20 of 39
Thread: Ballast problem
-
08-23-2017, 06:49 PM #11
Best pics I could get.
2019 Supra SL450
-
08-23-2017, 07:16 PM #12
Vent line coming thru floor should go directly to leg of the bow sac with NO check valve. Vent line for bow sac should be at the nose of the sac and go directly outside of the boat thru the hull with NO check valve.
Sent from my SM-G930V using TapatalkJoe
2014 LSV
2010 Outback V - Sold
1993 Echelon
-
08-23-2017, 07:21 PM #13
With this setup, the bag will drain almost completely by the time the tank is empty.
Sent from my SM-G930V using TapatalkJoe
2014 LSV
2010 Outback V - Sold
1993 Echelon
-
08-23-2017, 07:22 PM #14
With this setup, the bag will almost fully drain by the time the tank is empty.
Sent from my SM-G930V using TapatalkJoe
2014 LSV
2010 Outback V - Sold
1993 Echelon
-
08-23-2017, 08:01 PM #15
Agreed
Sent from my iPad using Tapatalk2017 Moomba Craz
-
08-23-2017, 11:02 PM #16
So it seems the hard tank is probably pretty much empty, but the bow bag isn't draining into it properly?
2019 Supra SL450
-
08-23-2017, 11:06 PM #17
To be clear, you mean the drain line through the floor (to hard tank) with no T to the vent and no check valve, and the fill line should have a T to the hose from the hard tank and to the vent, with no check valve?
I have 2 check valves and 3 Ts involved with the bow bag.2019 Supra SL450
-
08-23-2017, 11:11 PM #18
All you need is one hose going in from the hard tank at one of the legs (or both legs) and then a vent line from the tip, to the outside of the boat. No check valves for anything.
Sent from my iPad using Tapatalk2017 Moomba Craz
-
08-23-2017, 11:56 PM #19
OK I'll have to re-plumb it. So it fills and drains from the bottom fitting on one leg? The top fitting is only for venting?
2019 Supra SL450
-
08-24-2017, 12:22 AM #20