Results 1 to 10 of 499
Thread: AutoWake questions
Threaded View
-
06-13-2019, 04:10 PM #10Junior Member
- Join Date
- Sep 2017
- Location
- North Carolina
- Posts
- 20
I can't comment on the newer screen setup as I have a 2017. But the re-calibration made a huge difference to my ability to use (and enjoy) autowake on my boat. It shipped from the factor with a 1.1 offset, but it always felt way off when surfing (the boat was clearly rolled, but it kept reporting 0 roll and dumping all the ballast on the driver side to try to get to -3. So I used the inclinometer on my iPhone, dropped the boat into the water on a calm day with just me in the middle of the boat. And while the iPhone was reading 0 degrees, the boat was reading 2.8 degrees. So I went in and hit recalibrate and it adjusted the total offset to 2.9.
The wife and I went out after and had the best surf in a long while using Autowake.
Now to figure out the right speed... to get good push, we are down at 9.8, but sitting 5-6' off the back of the boat. And I'm running 1100's in the rear (upgraded from the stock 650s in the original Surf Edition).
heath2017 Moomba Craz Surf Edition
High altitude prop
1140 lb WakeMakers Universal Fit rear ballast upgrade
Autowake 2.0 firmware upgrade (20171121 version)
2013 SeaDoo GTI135SE with ski mode
1984 SeaRay 210 CC - traded