Results 1 to 4 of 4
-
08-02-2017, 02:12 PM #1Junior Member
- Join Date
- Aug 2016
- Posts
- 3
2004 LSV 3 switch bladder fill/empty controls electrical hookup to fuse block.
So, my kids mainly used this boat. It's time to sell and I'm trying to get everything working. Couldn't figure out why the bladders wouldn't fill. Put new ball valve, new solenoids, new sprinkler valves, checked the pump, and then found all 6 wires disconnected from the fuse block. Most likely from someone's feet under the dash. I tried to trace the color coded wires back to the 3 switches, left, right, front, and match them up with the fuse block left, right, front, but still not right. Each bag has 2 fuses,a 25amp fuse and center 10amp, left and right 3amp. Any ideas to find an electrical schematic for this hookup? Boat is 2004 Outback LSV with original factory setup.
-
08-02-2017, 04:03 PM #2
Maybe Bake's???
My Mom said I'm not allowed to get wet!
2008 LSV (sold)
2000 Outback LS (sold)
LLTR!!!!!!!!
-
08-02-2017, 04:19 PM #3Member
- Join Date
- Aug 2015
- Location
- DFW
- Posts
- 41
If it is the Gravity III setup, there would be one 12v and one negative wire connecting to the buss blocks under the helm.
The 12v goes to the fuse block, one row of fuses is for the drain pumps, and one row goes to the sprinkler solenoids (i believe 5 and 3 amp respectively).
On your switch panel, there should be a breaker button, I believe that breaker is for the single fill pump.
I just ripped my system out a couple of weeks ago, I will see about taking some pictures when I get home.2006 Moomba XLV
Indmar 325 MPI - Acme 1433
1,100lb V-drive sacs + 1,180lb front
WakeMAKERS Ballast System Upgrade
DIY SuckGate
PerfectPass DBW
-
08-02-2017, 10:50 PM #4Member
- Join Date
- Aug 2015
- Location
- DFW
- Posts
- 41
There is also a 40amp fuse just off the main 12v lead.
Here is the color code from my fuse block:
Pump Outs:
- Left=Orange/Brown
- Right=Orange/Red
- Front=Orange/Grey
Solenoids:
- Left=Orange/Purple
- Right=Orange/Green
- Front=Orange/Yellow
Last edited by zd215; 08-02-2017 at 10:54 PM.
2006 Moomba XLV
Indmar 325 MPI - Acme 1433
1,100lb V-drive sacs + 1,180lb front
WakeMAKERS Ballast System Upgrade
DIY SuckGate
PerfectPass DBW