16' Fill Times Really Short?

[Willyourun]

My boat was a dealer demo. Wonder if they upgraded the pumps? Probably a dumb question but how or where would I check to see the actual pump?


Sent from my iPhone using Tapatalk

[stevemarich]

They should be behind rear panel in the bag lockers , I have two starboard and on the port side, intro see what you come up with , because actually filling 1100s in 4 minutes is pretty sweet

[Stazi]

I can't believe you are filling 1100's in 4 minutes with the standard reversible pumps. Mine take 10 minutes. Center tank and bow bag is 15 minutes.


Sent from my iPhone using Tapatalk

[Willyourun]

Found the pump information. It is a Jabsco 18670-6127. I can't seem to find the exact model numbers online.

Not sure if that what would come normally or not?


Sent from my iPhone using Tapatalk

[jstenger]

Found this on the Jabsco site.

http://www.xylemflowcontrol.com/mari...r-puppy-us.htm

18670 Commercial Duty Water Puppy (US) Bronze DC Pump


Flow rate: 8 USgallons/min (30.4 Litres/min)
Self-priming from dry up to 1.2m (4ft)

Model No.: 18670-Series
•Small bilge debris present no problem to these bronze bodied, flexible impeller pumps.
•Simple design means fewer wearing parts.
•ISO 8846 MARINE (Ignition protection).
•ISO 8849 MARINE (Bilge pump standard).

-VS- this sold by Wakemakers.

http://www.xylemflowcontrol.com/mari...ze-dc-pump.htm

Ballast King Bronze DC Pump

Wakeboard and Ski boat Ballast Pump


Flow rate: 15 USgallons/min (57 Litres/min)
Self-priming from dry up to 1.2m (4ft)

Model No.: 22610 Series
•Adds approx 125lbs (56kgs) of ballast per minute
•Reversible to both fill and empty tanks
•Simple design means fewer wearing parts.
•ISO 8846 MARINE (Ignition protection).

[stevemarich]

Should be the standard pump then , if you are filling them full that quick that is awesome, might want to see a pic of your bags when their full

[Willyourun]

Will do. I'll try to video it too. Maybe I'm missing something obvious.


Sent from my iPhone using Tapatalk

[stevemarich]

Found this on the Jabsco site.

http://www.xylemflowcontrol.com/mari...r-puppy-us.htm

18670 Commercial Duty Water Puppy (US) Bronze DC Pump


Flow rate: 8 USgallons/min (30.4 Litres/min)
Self-priming from dry up to 1.2m (4ft)

Model No.: 18670-Series
•Small bilge debris present no problem to these bronze bodied, flexible impeller pumps.
•Simple design means fewer wearing parts.
•ISO 8846 MARINE (Ignition protection).
•ISO 8849 MARINE (Bilge pump standard).

-VS- this sold by Wakemakers.

http://www.xylemflowcontrol.com/mari...ze-dc-pump.htm

Ballast King Bronze DC Pump

Wakeboard and Ski boat Ballast Pump


Flow rate: 15 USgallons/min (57 Litres/min)
Self-priming from dry up to 1.2m (4ft)

Model No.: 22610 Series
•Adds approx 125lbs (56kgs) of ballast per minute
•Reversible to both fill and empty tanks
•Simple design means fewer wearing parts.
•ISO 8846 MARINE (Ignition protection).

I have seen that ballast king pump on wake makers, that would be a handy upgrade at some point, but man would it be a lot to swap all three pumps, the OP pumps seem to fill even faster than the ballast kings though, got to be miss something, or hes just lucky

[csm]

Might be worth measuring the dimensions to make sure you actually have 1100s. Maybe your dealer told you they were but actually gave you 750s? If not, I definitely want to know your secret.


Sent from my iPhone using Tapatalk Pro

[Willyourun]

Might be worth measuring the dimensions to make sure you actually have 1100s. Maybe your dealer told you they were but actually gave you 750s? If not, I definitely want to know your secret.


Sent from my iPhone using Tapatalk Pro

Bought the 1100's from Wakemakers. I checked that already. That was my first thought too.


Sent from my iPhone using Tapatalk