Results 1 to 3 of 3
-
06-14-2017, 12:18 PM #1Junior Member
- Join Date
- May 2016
- Posts
- 6
Tower rack is too large for boards
I have two roswell tower racks on my boat. One has 3 prongs made to hold two wakeboards. The other only has two prongs (I am assuming for a kneeboard). I'm trying to come up with ideas to make the opening smaller on the two prong rack as I have lost boards out of that rack in rough water.
I have thought of just using foam tubing around the prongs to make it a little smaller, but wondering if anyone has good ideas that may look a little cleaner?
-
06-14-2017, 12:24 PM #2
I have used shorten pieces of water noodles placed between the boards and the racks to keep them from bouncing around.
After you put the boards in slide a noodle in lengthwise parallel to the board between the two boards back to back so it presses the boards snuggly against the prongs . Then it will fit snug when you bungee it down.
I hope my explanation makes since.
2016 Supra SG 450Josh
2016 Supra SG 450
2001 Calabria Pro V - Sold
1987 Supra Sunsport - Sold
-
06-15-2017, 12:45 PM #3Senior Member
- Join Date
- May 2017
- Posts
- 116
Mine are too skinny to fit surfboards in, can only get a kids one in there.
2006 Mobius LSV
New to boating and surfing