Results 1 to 3 of 3
Thread: Seablaze 3 help
-
06-03-2017, 07:57 PM #1
Seablaze 3 help
Has anyone had issue before?
I recently purchased 2x seablaze 3 lights. Ran a 16g wire from each of them to constant power to the inside of the fuse block on 5amp inline fuses through a 40amp relay.
The issue I am having is that when I turn on the lights with the push button switch, they both come on and light up. One flickers on start up then fully illuminates. After about 10-15 seconds it dims right down then goes into what seems like a safety mode where in blinks off and on.
I ran the power straight to the battery and didn't seem to have a problem.
Any advise would be greatly appreciated.
Sent from my iPhone using Tapatalk
-
06-03-2017, 09:25 PM #2
I would add a relay to the system between the switch and the lights.
Sent from my SAMSUNG-SM-G930A using Tapatalk2006 Supra 20 - Sold
2006 Supra 24 Gravity Games - Sold
2015 Supra SE450 - Sold
-
06-05-2017, 07:15 AM #3
There is a relay between the switch and system. I'm not sure what else could be the issue. It seems like it's not getting adequate power or something.
Sent from my iPhone using Tapatalk