Results 21 to 30 of 64
Thread: Tint
-
03-02-2017, 07:16 PM #21
-
03-02-2017, 07:18 PM #22
-
03-02-2017, 07:36 PM #23
Before you remove it, take photos of where the windshield supports attached and the position they are in. After you pull the Rubber seal out to expose the screws it's as easy as just removing them, each main panel will have one bolt with a nut that you have to access from underneath. You can typically tell which one this is because it has a slightly larger head.
Once it is all unscrewed the glass lifts right off of the boat. I have found that it goes back on the boat better if you have not had to move or reposition the boat / trailer at all. And even then it just takes a little bit of time to get the center glass alignment back.
When I take them to my tinter, he drills out the rivets and removes the metal trim and the rubber trim, tints it, then reassembles everything with stainless rivets and you can't ever tell it was taken apart
Sent from my SAMSUNG-SM-G930A using Tapatalk2006 Supra 20 - Sold
2006 Supra 24 Gravity Games - Sold
2015 Supra SE450 - Sold
-
03-02-2017, 08:44 PM #24
Thanks for the tip!
2016 Craz.
Enzo bags.
-
03-02-2017, 09:06 PM #25Member
- Join Date
- Jul 2013
- Location
- De Pere, WI
- Posts
- 51
-
03-02-2017, 09:10 PM #26
-
03-02-2017, 09:12 PM #27
-
03-02-2017, 09:25 PM #28
-
03-03-2017, 12:25 AM #29
I did 20% once. Now I only do 5%
Sent from my SM-G930V using Tapatalk-Jake
-
03-03-2017, 06:19 AM #30
On the LSV I took the windshield apart, and just gave them the glass. The tint was perfect, but the windshield never looked as good around the rubber seals as before it was taken apart.
On the Mojo I took the windshield off the boat, but didn't take it apart. I have a small 1/8-1/4 gap around the inside of the windshield that I cover with black 3m tape. The tint looks just as good otherwise and the seals all look original.
The nice thing as the years have gone by the tint gets scratched, there is a couple really small defects showing up, with it not being extended to the seals its much easier to remove and re-tint. Just a thought.
08 LSV with 5%
13 Mojo with 5%
Malo <--- Means--Evil or Mean One. This explains a lot.
2013 Mojo 2.5 Skylon Tower. Bestia < Beast >
[COLOR="#696969"]