Results 1 to 4 of 4
-
02-25-2017, 11:41 AM #1Junior Member
- Join Date
- Jun 2016
- Posts
- 6
Wiring question - tower speaker install
I have an '06 Outback and in the middle of installing some amps and tower speakers. I have the wiring ran down the front port leg's factory hole. I have the bolt-on style front legs fyi. My question is, how did you guys get the wiring to the inside of the boat? Pictures would be a HUGE help if possible!
-
02-25-2017, 12:14 PM #2
Drill holes !!
2016 Supra SG 450Josh
2016 Supra SG 450
2001 Calabria Pro V - Sold
1987 Supra Sunsport - Sold
-
02-25-2017, 03:50 PM #3
If you have a tower mounted light from the factory, they should have run the wires out of the base of the starboard leg and then through a hole in the hull, via a Deutsch connector that has a flange screwed to the hull. Buy the same connector and duplicate the the method they used to go through the hull.
https://smile.amazon.com/Deutsch-14-...ange+connector2017 Moomba Craz
-
02-25-2017, 04:50 PM #4Junior Member
- Join Date
- Jun 2016
- Posts
- 6
Thanks for the help! I was hoping I could just lift the tower foot and slide it in through there but I think the factory-matching connector definitely works better for me!