What screw driver to tighten the bolts at the bottom of the OZ HD Tower?

[BrettLee3232]

Am I the only one who's screw comes loose on the tower? There's no easy way of tightening it. I haven't found a big enough flat head that doesn't start to strip it. Anyone have a recommendation of a screwdriver to buy?


Sent from my iPhone using Tapatalk

[russellsmojo]

Am I the only one who's screw comes loose on the tower? There's no easy way of tightening it. I haven't found a big enough flat head that doesn't start to strip it. Anyone have a recommendation of a screwdriver to buy?


Sent from my iPhone using Tapatalk

I had to tighten it every 2 to 3 trips out. I used a flathead screwdriver. A really big one. One trick I found was to take some pressure off the tower by pushing up on it. Then it would tighten real easy.


Sent from my iPhone using Tapatalk

[jstenger]

+1 on lifting the tower. Had to tighten them once. There is a lot of pressure on those bolts from the weight of the tower.

[BrettLee3232]

Yeah I have to lift the tower to relieve stress but it's still a pain in the ass. I wish I could find a screw driver that was shaped like a tire iron so I could get some good torque on it lol.

I've looked at t-handle screw drivers but I haven't found a big enough one yet.

Mine get loose every trip. It's so annoying.


Sent from my iPhone using Tapatalk

[russellsmojo]

Yeah I have to lift the tower to relieve stress but it's still a pain in the ass. I wish I could find a screw driver that was shaped like a tire iron so I could get some good torque on it lol.

I've looked at t-handle screw drivers but I haven't found a big enough one yet.

Mine get loose every trip. It's so annoying.


Sent from my iPhone using Tapatalk

Buy more speakers to weight the tower down so it cannot loosen.


Sent from my iPhone using Tapatalk

[tnbrooks01]

Yeah I have to lift the tower to relieve stress but it's still a pain in the ass. I wish I could find a screw driver that was shaped like a tire iron so I could get some good torque on it lol.

I've looked at t-handle screw drivers but I haven't found a big enough one yet.

Mine get loose every trip. It's so annoying.


Sent from my iPhone using Tapatalk

Take them out one at a time and coat it with red threadlocker. I use the largest flathead I have and use a cresent wrench on the grip for more twisting force. That was the only way to stop them from vibrating loose.


Sent from my iPhone using Tapatalk

[BrettLee3232]

Take them out one at a time and coat it with red threadlocker. I use the largest flathead I have and use a cresent wrench on the grip for more twisting force. That was the only way to stop them from vibrating loose.


Sent from my iPhone using Tapatalk

Thank you!


Sent from my iPhone using Tapatalk

[bjrow]

Hey mate same problem here originally.
Used a stainless ruler end, pulled each one out and put thread locker on it then replaced.
Been out about 20 times since and all good.
Cheers BruceR...from the other end of the world.

[BrettLee3232]

Hey mate same problem here originally.
Used a stainless ruler end

How do you use a stainless ruler end?

All I can think of is in elementary school when the teachers had a 3' ruler lol



Sent from my iPhone using Tapatalk

[bjrow]

Here's a pic, just used it carefully while moving the tower up/down etc.

DSC_0346.jpg

Cheers BruceR