Results 1 to 4 of 4
Thread: trailer DIY swing away
-
11-30-2016, 10:18 AM #1
trailer DIY swing away
Anyone use these, I was looking to do one on my pontoon trailer if needed for new garage .
http://www.etrailer.com/Folding-Tong...FVoaAt5E8P8HAQA Day at the Lake...Priceless
A Day in Powder...Endless
Joe V
2012 Möbius XLV~ Loaded & Exiled
2007 Outback V ~ sold
-
11-30-2016, 01:53 PM #2
Joe, I did one on my 2004? 18' Key west bay boat a few years back. Super simple to do, they gave a guide to make the cut with, then its just drilling holes and bolting in back together. Must of done it ok as I saw the boat and trailer a few months back and it was still in use, and that's with the trailer being dunked in salt water
Hey, Its Moomba time
Its all about the dash - enjoy the dash, as that is your time between the dates
13 Mobius LSV-sold
08 Mobius LSV-sold
03 Mobius LSV-sold
life is about finding the balance between being a responsible adult and staying young at heart
-
11-30-2016, 03:45 PM #3
thanks, this trailer will get used twice a year once I get it.
A Day at the Lake...Priceless
A Day in Powder...Endless
Joe V
2012 Möbius XLV~ Loaded & Exiled
2007 Outback V ~ sold
-
12-01-2016, 01:09 PM #4
Can't be too hard. Long as there are no brakes to deal with. Good luck!
My Mom said I'm not allowed to get wet!
2008 LSV (sold)
2000 Outback LS (sold)
LLTR!!!!!!!!