Results 1 to 4 of 4
Thread: Solenoid Help!!!
-
10-02-2016, 05:50 PM #1Junior Member
- Join Date
- Sep 2016
- Posts
- 4
Solenoid Help!!!
My ballast were taking on water (with the switch in the correct position) so I went and bought the replacement Orbit vales. However, the old solenoids have the special clip style adapter. The wires are not marked. I was going to cut and splice, but how do I know which one is which?? Help is appreciated!!!!
Thanks,
Rob
-
10-02-2016, 07:05 PM #2
It doesn't matter which goes to which.
Sent from my Nexus 6 using Tapatalk2008 OBV
325 EFI with closed cooling
Gravity III with 750's in the rear, 400 stock floor, 750 IBS
Servo valve ballast upgrade
Wetsounds Rev10
JL Amps, WS420BT
2000 Outback LS <-- Sold!!!
310 Carb Direct Drive
800# Rear Locker
750# IBS (should have kept this for the OBV)
Dual Batteries with 2 Bank Charger System
Kenwood Head with Remotes
Too many hours restoring exterior from prior negligence to count!
-
10-03-2016, 08:07 PM #3
Ditto san!
My Mom said I'm not allowed to get wet!
2008 LSV (sold)
2000 Outback LS (sold)
LLTR!!!!!!!!
-
10-06-2016, 06:12 AM #4Junior Member
- Join Date
- Sep 2016
- Posts
- 4
Thanks guys!!!