Results 1 to 8 of 8
Thread: Growling/Vibration
-
08-07-2016, 10:41 PM #1
Growling/Vibration
2014 Möbius LSV with 330 assault. Running Acme 1433 prop. Just recently my family and I have begun to wake surf. When the stock rear and center bags are full and getting going at 10 mph I can feel a vibration and hear a growling noise coming from trans/motor area. The noise only comes when boat is heavily loaded. All wakeboarding actions nothing can be heard. I have used boat for a few days and noise has not gotten worse or better. I am going to switch to my stock 537 prop and see if noise is there still tomorrow. Any ideas before I take in to shop?
Thanks
-
08-07-2016, 10:47 PM #2
Growling/Vibration
2013 LSV Red/White
1100lb upgrades in each rear locker!
Stock 500 Bow ballast
650IBS
Manual Flow equipped
Boards
Hyperlite Hi-Fi "The Illest"
CWB AMG Carbon
Phase 5 Razz
Byerly Volt
4.6 Ronix Koal Fish
Phase Five Scamp (kiddos)
-
08-08-2016, 09:07 AM #3
Mine has been doing this ever since I bought it in 2010. The stock OJ prop was supposedly known for this and swapping to an ACME was the fix, well I swapped to an ACME 1847 like 4 years ago and it still growls/vibrates.
David
2017 Moomba Mojo Max Surf Edition, 2 Pair Wetsounds Rev10s powered by an SD2, 6 pair Wetsounds XS650M and Wetsounds XS12 powered by SD6 all controlled by a WS420. 2 Lumitec SeaBlaze X2 Spectrum underwater lights
SOLD***2008 Mobius LSV, Gravity III , Wake Plate, Z5, Exile SX65c's, Exile XM9s, Exile XI12D, Exile Javelin, Exile 30.2***SOLD
-
08-08-2016, 02:25 PM #4
Definitely check your drive shaft coupler bolts. Should do this at every oil change.
My Mom said I'm not allowed to get wet!
2008 LSV (sold)
2000 Outback LS (sold)
LLTR!!!!!!!!
-
08-08-2016, 10:40 PM #5
Growling/Vibration
2013 LSV Red/White
1100lb upgrades in each rear locker!
Stock 500 Bow ballast
650IBS
Manual Flow equipped
Boards
Hyperlite Hi-Fi "The Illest"
CWB AMG Carbon
Phase 5 Razz
Byerly Volt
4.6 Ronix Koal Fish
Phase Five Scamp (kiddos)
-
08-09-2016, 08:10 PM #6
I checked mine over too. Everything tight. Im gonna do a propsaft alignment as when I checked that I could get .007 in at port side at like 2 o'clock and 6 o'clock.
I don't really know if that small amount out of adjustment would make a difference.
-
08-14-2016, 12:32 AM #7
After prop shaft alignment and putting my new 1617 on. all is well. I may have a prop problem sending out to Nettles on Monday. One thing to note I never properly lapped my 1433 when installed. That may have been my issue all along. I will find out next week if prop was out of balanced.
-
08-14-2016, 08:24 AM #8David
2017 Moomba Mojo Max Surf Edition, 2 Pair Wetsounds Rev10s powered by an SD2, 6 pair Wetsounds XS650M and Wetsounds XS12 powered by SD6 all controlled by a WS420. 2 Lumitec SeaBlaze X2 Spectrum underwater lights
SOLD***2008 Mobius LSV, Gravity III , Wake Plate, Z5, Exile SX65c's, Exile XM9s, Exile XI12D, Exile Javelin, Exile 30.2***SOLD