Page 1 of 3 123 LastLast
Results 1 to 10 of 29
  1. #1
    Join Date
    Jan 2014
    Location
    Kelowna, BC Canada
    Posts
    426

    Default Ballast bag/wakeplate not working - fuse location?

    So I just got my Autoflow 2.0 installed and I got the boat back onto the water for the water test. Went to fill the ballast bags up and no juice to the pumps. Also the wake plate will not go up or down.

    I spoke with the owner of the shop that did it and was told that the fuses probably were bumped by an installer and to reset them. He wasn't 100% sure where the switches were located because they do quite a bit of Supras but not Moombas.

    You guys have any idea where I might find them? Would save me a trip back ... but sounds as though I am going to have to take it back over to the shop to have them fix whatever was done.

    LMK if you have any ideas. Thanks.
    2014 Black/White Mojo
    345HP Surf Motor
    1235 Prop
    Autoflow 2.0 Upgrade
    1100# FlyHigh Rears
    650# IBS
    4 x Exile SXT9q's w/ Exile 30.2 amp and Exile ZLD controller
    Exile Javelin Amp
    10" Rockford sub

  2. #2
    Join Date
    Jan 2014
    Location
    Kelowna, BC Canada
    Posts
    426

    Default

    BTW here are pics of it done - also costed me $1000 over the quoted price. The gel work/paint came in substantially more because my manual flow system had quite a few more holes in it than the Supras they usually do. That sucked big time but wasn't much I could do.





    Last edited by blackcup; 05-19-2016 at 03:12 AM.
    2014 Black/White Mojo
    345HP Surf Motor
    1235 Prop
    Autoflow 2.0 Upgrade
    1100# FlyHigh Rears
    650# IBS
    4 x Exile SXT9q's w/ Exile 30.2 amp and Exile ZLD controller
    Exile Javelin Amp
    10" Rockford sub

  3. #3

    Default

    Check in the rear lockers.

  4. #4
    Join Date
    Jan 2014
    Location
    Kelowna, BC Canada
    Posts
    426

    Default

    Nothing in the lockers but the ballast bags.
    2014 Black/White Mojo
    345HP Surf Motor
    1235 Prop
    Autoflow 2.0 Upgrade
    1100# FlyHigh Rears
    650# IBS
    4 x Exile SXT9q's w/ Exile 30.2 amp and Exile ZLD controller
    Exile Javelin Amp
    10" Rockford sub

  5. #5
    Join Date
    Jul 2008
    Location
    Snellville, GA & Lake Sinclair
    Posts
    8,419

    Default Ballast bag/wakeplate not working - fuse location?

    There should be a breaker on the engine divider panel on the port side. Check to see if it is tripped.

  6. #6
    Join Date
    May 2013
    Location
    Fairfax, VA :(
    Posts
    925

    Default

    For the extra $1,000 they should come out, wipe the excess sealant from the transom and fix the issue. Hopefully that is it and they didn't knowingly let a problem go out the door.
    2007 XLV Gravity Games
    Full Wake Makers upgraded ballast and pumps
    1,100 in each rear locker
    1,180 in front
    OJ 1435 prop, 325 EFI Indmar Assult.
    Fresh Air Exhaust
    SuckG8
    Bunch of other crap

  7. #7
    Join Date
    Jan 2014
    Location
    Kelowna, BC Canada
    Posts
    426

    Default

    I couldn't agree more. Heading to the boat today to see if flipping the breaker will fix it and if not I'll make sure they come out.
    2014 Black/White Mojo
    345HP Surf Motor
    1235 Prop
    Autoflow 2.0 Upgrade
    1100# FlyHigh Rears
    650# IBS
    4 x Exile SXT9q's w/ Exile 30.2 amp and Exile ZLD controller
    Exile Javelin Amp
    10" Rockford sub

  8. #8
    Join Date
    May 2013
    Location
    Fairfax, VA :(
    Posts
    925

    Default

    Sorry, I don't men to burst your bubble. That is an awesome add-on! I hope it works and just in time for summer.
    2007 XLV Gravity Games
    Full Wake Makers upgraded ballast and pumps
    1,100 in each rear locker
    1,180 in front
    OJ 1435 prop, 325 EFI Indmar Assult.
    Fresh Air Exhaust
    SuckG8
    Bunch of other crap

  9. #9
    Join Date
    Jan 2014
    Location
    Kelowna, BC Canada
    Posts
    426

    Default

    Yeah I know what you are saying ... definitely doesn't feel awesome thats for sure. Was super stoked to get it out last night and see the wave ... and then hitting the ballast switches and nothing happening was definitely a buzz kill. Still dealing with my terrible sounding 4 x Exile SXT9Qs and that whole fiasco as well. Fingers crossed it is a quick fix like a breaker or something ... but considering how everything boat related has been going thus far I don't have my hopes up.
    2014 Black/White Mojo
    345HP Surf Motor
    1235 Prop
    Autoflow 2.0 Upgrade
    1100# FlyHigh Rears
    650# IBS
    4 x Exile SXT9q's w/ Exile 30.2 amp and Exile ZLD controller
    Exile Javelin Amp
    10" Rockford sub

  10. #10
    Join Date
    May 2013
    Location
    Fairfax, VA :(
    Posts
    925

    Default

    Damn that really sucks. I would go for fixing the wake to start with myself. Can't surf without it.
    2007 XLV Gravity Games
    Full Wake Makers upgraded ballast and pumps
    1,100 in each rear locker
    1,180 in front
    OJ 1435 prop, 325 EFI Indmar Assult.
    Fresh Air Exhaust
    SuckG8
    Bunch of other crap

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •