FAE install on MOJO

[dusty2221]

I do not have a gap

[dusty2221]

Here are a few more photos

[lsupcar]

Thanks Dusty. The pictures are helpful.
The exhaust output flange on your supra is different from my Mojo.

[mmandley]

Dusty,
One other question.
When mounting the FAE to the boat exhaust flange, how tight a fit was it? Did you have to sand down the flange some to get it all the way on? Does the FAE flange seat firmly against the lip of the exhaust flange or is there a gap?
Thanks.

This will mount like all the other Moomba boats to the exhaust flange.

The rubber flap has a band clamp you remove, then it pulls off and you have a plastic exhaust flange. FAE will send you an aluminum insert so you can mount the rubber hose from the FAE pipe to it. This tends to fail. So most screw the rubber extension hose from the FAE to the plastic exhaust flange.

I know yours is a solo due to Raptor engine but still same concept.

Before with Rubber Flaps.




This just shows how the Rubber boot goes from the FAE over the outside diameter of the Exhaust flange. I put 4 screws through the rubber boot into the plastic flange, then used a band clamp over the screws so they can't back out. 5 seasons and never an issue on 2 boats.

[lsupcar]

Thanks Mandley.
Mine is built without the rubber connection similar to Dusty's, but will fit over the protruding flange of the exhaust outlet like your rubber hose does. A metal lip on the FAE abuts the lip of the exhaust outlet and the four screws of the exhaust outlet hold everything on.
The FAE to exhaust outlet junction is very tight, thus my question to Dusty about whether he had to sand his down to get it to fit. His outlet is a different design then ours as you and I now know.
FAE is working hard to get everything perfect. This is a new model for them.
Bill

[nitrodude24]

I order fae back in the fall group buy and it didn't fit correct I've sent mine back to Larry for mods. I had a 1/4 to 3/8 gap from the outlet to the flange.

[lsupcar]

nitrodude,
Have you received your final product back yet?
I ordered mine in the fall group buy as well, but was not able to submit my boat's measurements until after
christmas so am only receiving mine now.
What was your solution to the tight flange to exhaust outlet fit?
Bill Z