Results 11 to 11 of 11
Thread: Strip LED install
-
05-05-2016, 03:25 PM #11
I believe that you can wire them in series, look at the end where they are sealed and if there are 2 small strips of metal under the silicone you can cut the edge off and solder to them. Its not super easy though. On the RGB ones I Installed the max current was shown on the bottom of the little power supply so that is just what I fused it at. I am not sure what you need on these but you do need a fuse like mentioned above.
Sean
2004 MOOMBA Mobius LS
1987 Kawasaki JS-550 (What was I thinking?!)
2004 Kawasaki STX-12f
2002 Kawasaki STX-R (BrAaAaPp!?!)
2007 Kawasaki Ultra LX (shhh... it's got a vortech )
2001 Toyota Tundra (Long Travel Tow Vehicle )
Checkout my LED project here!