autoflow

[jmvotto]

I heard 3500 to 4000 installed , spring , summer 16, but it is not out yet as Joe stated above

[BrettLee3232]

You will need the larger upper arms also.

Larger upper arms for AutFlow 2.0 or for FAE?

I just order the 2.0 tabs for my Mondo and he said a direct replacement...easy swap out.


Sent from my iPhone using Tapatalk

[jstenger]

Larger upper arms for AutFlow 2.0 or for FAE?

I just order the 2.0 tabs for my Mondo and he said a direct replacement...easy swap out.


Sent from my iPhone using Tapatalk

You need the larger upper arms for Autoflow 2.0 since the larger tabs generate more force. Luckily they use the same hole pattern.

[BrettLee3232]

You need the larger upper arms for Autoflow 2.0 since the larger tabs generate more force. Luckily they use the same hole pattern.

Hmmmm, odd they didn't mention that to me. I guess we will see when they arrive lol


Sent from my iPhone using Tapatalk

[BrettLee3232]

You need the larger upper arms for Autoflow 2.0 since the larger tabs generate more force. Luckily they use the same hole pattern.

Just spoke with the manufacturer and he said....

We did enlarge them a little due to worst case senecio on testing but unless you are trying to power turn with plate deployed or use the blades as a step you should be fine.

They use the same mounting holes. The only thing that would be some extra work on your end would be cut the actuator leads so you could remove current arm mounts. Then having to wire/solder them back and use water tight heat shrink tubing

Sent from my iPhone using Tapatalk

[nitrodude24]

Brett Lee what will the retro cost you for the parts

[BrettLee3232]

Brett Lee what will the retro cost you for the parts

PM sent


Sent from my iPhone using Tapatalk