I could have sworn there was another thread about this that I even replied in but darned if I could find it while on my phone.

Anyways, one of my brakes is locking up bad, hubs get SUPER hot. Took wheel off, caliper and pads and from what I can tell the piston (I am guessing that it what it's called) is out too far. I pulled off the other wheel to compare and it seems to be locked out further than the other which means the brake pads are in constant contact with the disk.

Trouble is, I don't know how to get this piston to push back in. Any insight from you "much smarter than me" guys?

Here is a pic of what I am referring to:



Thanks.